Reseñas de clientes para VEVOR Juego de Machos y Matrices, Juego de Machos y Matrices Métricos,110 Piezas Tungsteno, Herramienta de Roscado y Roscado de Tungsteno para Máquinas Herramienta/Módulos de Precisión/Transformadores

muy buena calidad y muy buen precio

Great set, has a vast range of sizes and easy to transport. Seems very durable

The quality of the taps looks good, and now I have taps for almost any threads! The quality of the plastic case is actually pretty bad. The locks is not tight, so I would not trust them. There were also one taps loose inside the case when I opened it. It cannot click back on its case. Would rather pay some more for better quality on the case.

Pros: Many sizes from very small to large with many pitch and TPI. Perfect to make new threads on soft metals like Aluminum, Copper Brass etc... Useful to use as thread chaser or thread cleaner. Cons: The Dies and Taps made of soft metal and cannot make new threads on steel. Some Dies and Taps need to be deburred before used. Some Dies and Taps are missing and populated by double already included.

Good value comprehensive set of metric taps and dies. I haven't checked them all yet, and I have heard some of the pieces aren't the best quality, but I can't confirm this comment.

I bought this set to obtain some of the fine metric sizes, and to double up on some common metric sizes. The steel is a chrome moly type tools steel (NOT HSS) and done in typical chinese quality for the price range. I found 6 of the taps, and 4 of the dies were unusable due to malformed thread, or manufacturing defects (thread not square to axis, burrs in machining hardened in place, cutting edges not formed properly) Most of the smaller size taps (say 5mm or less) were not a sharp as a P&N/ SUtton HSS tap, but also considerably cheaper - so resharpen, or use with care. Sizes above 5mm were generally OK and those bigger than 9mm were comparable to the older kincrome sets. Tap wrenches, die stocks appear to be steel under the paint, so should be adequate. I would reccomend for 5mm and up in non ferrous metal work, but go gentle in steel or smaller sizes. For a one off unusual size it may be price effective, but if tapping a lot of 6,8,10,12mm holes, it would be worth upgrading the taps to HSS based ones. NOTE - After sales service - Vevor obvioulsy don't really understand how these tools are used, but their sales support people really tried to sort this out, and did try to substitute the faulty taps/ dies, but found their floor stock had similar issues. They escalated to their supplier, and compensated me for the unusuable components

The cases seem to me not to fit the tap and die were scattered all over when you open the lid. It seems to me to work just fine.

Fantastic set, great price, heavy duty case. You could buy a better set but it would cost you a lot more.

Wanted a good set, but also one that included an M11x1 which is an odd sizing but was something I needed to use straight away. Taps are better than average but not presto sharp which is to be expected. Dies are not great but work (mainly smaller sizing has machining burrs swarf left behind and inconsistencies) they clean up but it's not what you expect . The set came particularly handy this week when my vevor slip roller arrived and was terrible quality. I had to use the set to chase 2 or the 3 adjusting screws and retap one casting. Slip roller I would avoid.

J'aurais aimé trouver un coffret avec beaucoup plus de tarauds en pouce. Celui-ci couvre la majorité des pas courants mais plus de choix sur les pas fins aurait été plus intéressant