Reseñas de clientes para VEVOR Plataforma Elevadora para Motocicletas 41,5 x 35 cm Elevador de Motos Hidráulicos de Tijera Capacidad de 158 kg Mesa Elevadora con 2 Ruedas Elevación de 340-905 mm para Taller Garaje, Naranja

Mooie en degelijke motorfietskrik. Opgelet! niet bruikbaar bij motorfietsen waar de knalpot/uitlaat onder de motor loopt!

I tried to change my order because I missed the one with the caster. It feels unsafe without the caster, but unfortunately, there is no way to go back to it to change it, and it is very difficult to return the product, and I still have not opened the box. I just have to be careful when buying at this store from now on. Because their policy says "you cannot exchange or buy additional parts unless you buy a new one with it." No, I don't recommend this product and their policy.

my bike that ways just over 400 lbs with no problem. In fact the jack was so easy to raise up I was able to turn the crank lever by my foot while balancing the bike. Tried lifting a Harley Sportster 883 that weighs over 600 lbs with no issue. However, I noticed the lift wasn't lifting the bike evenly. The front shaft that moves on the bottom plate when the lift is raised started to go at an angle. The holes that you insert the safety pin in didn't line up. I'm not sure if the weight of the bike had anything to do with the front shaft lifting at a angle or the lift didn't like the location where it was on the bike. I lowered the bike to see if there was a problem with the lift but it looked normal. I relocated the lift to another lifting point and same issue. Although it didn't look right the lift held up the bike with no problem. I didn't notice anything wrong when I lifted the 400 lb bike. All in all it worked but I not sure if will be an issue next time I need to use it.

This lift was exactley what I was looking for. I used it only twice and lifted approx 30 - 35 kg both times. But there was a leak of oil from the bottom of the cylinder and I couldn't use the lift. Contacted support. After some investigating I was first offered to get a new sealing ring but I don't know how to do the replacement since I do not have the skill to repair hydraulics and asked support to send me a complete lifting cylinder, that's is quite easy to do. Instead i was offered 739 SEK which I decline. I wrote that I want a complete cylinder but they will not send any due to logistic (which I don't believe in). Next step was to offer me 1439 SEK and I declined since I will have a new complete cylinder and they still won't send me a new one. Finally I was offered 2429 SEK (all money back) and they will still refuse to send me a new cylinder. I gave up and took the offer. Now a have an useless lift and I will take it to the scrap yard.

Problem ticket issue ignored and my stand is still sitting to the side broken.

J ai acheté le lève moto avec roulettes,J ai un sportster 1200 Ne pas en dessous avec les roulettes aucun intérêt

Was cheap i guess but be careful if you are not paying attention you can unwind nut to far and the nut will come of and the whole thing will collapse on you and bike will land on you and vevor will not help you at all can cause very serious injury so be careful when use this lift jack

Descripción confusa que induce al error y atención al cliente pésimo no recomiendo comprar en vevor tengoncompañeros de trabajo que les a pasado lo mismo.

I was sent a broken unit No hydraulic power at all.

I've bought a lot from vevor. Rarely disappointed. Good build price etc but! Not exactly as described in video and manual. Locking device is shown as 3 dowels welded onto base frame either side for locking device. Mine came with 3 little indents approx 2 mill deep either side for mechanism to register against. Scary ,I'll have to modify to increase safety. Not impressed.