Reseñas de clientes para Bomba de recirculación de agua caliente VEVOR, 10 GPM, sistema de circulación instantánea, control de 3 velocidades, 0,13 HP, 110-120 V, adaptador NPT de 3/4" a NPT de 1/2", cabezal de acero inoxidable, para calentadores de agua.

Polecam

This pump work perfectly for a recirculating pump, with the built in controls it far exceeds traditional pumps.

Ottimo prodotto e serio rivenditore

Ein wegen des Edelstahlpumpenkörpers hervorragendes Erzeugnis zu einem äußerst günstigem Preis. Auch hochwertiges Zubehör. Schnell geliefert. Bessergeht nicht, ich werde bestimmt wieder bei Vevor kaufen!

I just have to comment on the incredible customer service I received from Vevor. I had to communicate several times with Vevor regarding the installation obstacles I was having due to the age and configuration of my home plumbing system. Customer service was always there with a prompt and courteous response never seeming to get frustrated with my issues. I will definitely be looking at Vevor for future purchases. Customer service is so important for online sales and I can definitely say that Vevor gets it.

Buenos días, les solicitamos factura de esta compra para la gestoría, pero aún no se ha descargado. No sé si es que hay algún problema, gracias.

Ottimo rapporto qualità prezzo

Montata oggi e messa in funzione sul mio impianto di ricircolo. Fa il suo lavoro in maniera silenziosa

I bought this unit. I’m not an expert, but after reading the reviews, most of them are very bad because nobody can figure out how to install it. After four days, and using some information I found, I was finally able to connect it properly and make it work correctly. So, how do we connect it? Let’s start here. This side is for cold water. The cold water comes in through here, goes through this line, continues through here, and finally connects here. So this part goes to the cold water line going to the faucet. Now let’s move down here. This is where the hot water goes in. This is the hot water inlet. This is where I installed the piece that came with it. Take a good look at that piece: it has an arrow, and that arrow must point upward. Then, this line goes to the hot water faucet, and this is where the hot water is taken from. This setup has been working perfectly for me. I’ve been using it for three weeks now and haven’t had any problems. Honestly, the instructions are not clear. They talk about Wi-Fi and other things that have absolutely nothing to do with the installation. So here I already connected everything so you can see how to do it correctly. The key piece is this one, and it’s very important to place it in that direction, on the hot water side. Okay? Thank you.

It is working really well. My old pump went out and this is doing everything it should. The question will be longevity.