Reseñas de clientes para Bomba de recirculación de agua caliente VEVOR, 10 GPM, sistema de circulación instantánea, control de 3 velocidades, 0,13 HP, 110-120 V, adaptador NPT de 3/4" a NPT de 1/2", cabezal de acero inoxidable, para calentadores de agua.

Je suis content de mon achat. En revanche déçu de la livraison UPS. J’ai dû aller chercher moi même la pièce en agence UPS car le livreur n’est pas passé à la maison ni me contacter. Pourtant le numéro de téléphone était bien noté sur le carton. J’en conclu que vevor a bien fait son travail et la faute est à UPS. En agence elle m’a dit que c’était un sous traitant qui était en charge de livrer.

tutto ok azienda super onesta e disponibile

sostituita alle piu blasonate , fa il suo lavoro e bene

Tube un acierto al comprasela a Ustedes. Muy rapido el envio a casa, trabaja bien y muy silenciosa.

Arrivata confezionata molto bene, è silenziosa l'ho presa senza timer perche destinata ad altri servizi

Necesito que me emitan la Factura de este Producto

Werkt heel goed.

Bought this and installed it. Works great!!! I have home assistant controlling the pumps on/off time. I now have instant hot water at all my top-floor taps, no more waiting for the hot water. I should have bought this years ago

We did a different set up. We took the hot water pipe from the hot water tank and put a set of by pass valves in. This way if the pump screw up it can be bypassed without doing major fixes later. It did take the time to get warm water upstairs down from 25 seconds to 5 seconds straight out of the box. I am still figuring out the settings to make some adjustments. I did increase the water flow rate on the pump so i havent lost any water pressure to my whole house even with the crazy looking bypass set up. Make sure you use good teflon tape, the tape that is provided is trash and caused leaks but i changed all the fittings to good tape then didnt have leaks. We have the return loop in our ensuite bathroom upstairs and havent had any issues with that. We also had 3/4 water lines so i had to do a pit of pipe and PEX management to get everything to fit into and screw onto each thing appropriately. My brother has this pump too and his has held up a year or more already so they seem to be worth the DIY project to get hot water throughout the house faster. My knocks are the instructions are kinda trash and there aren’t many good videos on the installation and set up for this water recirculator.

Bought two of these to stop running water until it gets hot. I have not installed it yet but I tested them in air when they arrived and they run too quiet to hear. It'll take some time to set one up as it will be the return for the longest hot water line, back to the drain valve at the base of the hot water heater. 120 feet from "hot" out to "cool" return. Also plan on a programmable temperature controller to start pumping when the water is slightly warm and shut off the pump once the return temperature becomes hot...to save the pump from really hot water. That controller is about $20 on Aliexpress. Good luck with your project. Only 4 stars because I haven't installed and tested it yet.