Reseñas de clientes para Bomba sumergible para pozos profundos VEVOR, 3 HP/2200 W, 230 V/60 Hz, caudal de 37 GPM, altura de elevación de 640 pies, con cable eléctrico de 33 pies, bombas de agua de acero inoxidable de 4 pulgadas para uso industrial, de riego y doméstico, grado de impermeabilidad IP68.

Cumplio con mis expectativas!

Estoy muy satisfecho con esta bomba sumergible Vevor de 3 HP. La instalé para abastecer agua desde un pozo y desde el primer día ha funcionado de manera excelente. Tiene muy buena potencia, mantiene una presión constante y mueve una gran cantidad de agua sin ningún problema. La construcción se siente sólida y resistente, y la instalación fue más sencilla de lo que esperaba. Incluso después de varias semanas de uso continuo, la bomba sigue funcionando de manera silenciosa y eficiente. También me sorprendió la relación calidad-precio, ya que ofrece un rendimiento comparable al de equipos mucho más costosos. Si buscas una bomba potente, confiable y con buen desempeño para uso residencial, agrícola o de riego, definitivamente recomiendo este producto.

Everything was as pictured thanks 😊

Worked excellent the first time I used it. I would buy again.

I purchased the VEVOR 3 hp submersible pump after my Well ran dry as an upgrade to my one horse pump and I’m very pleased with this upgraded Pump. It has worked flawlessly. I’ve had no problems with it since I installed it after having a new Well dug 120 foot deep. can’t be surprised.!

The pump was by far less expensive and it works great the flow and the pressure is more than what I expected got great use out of all ready

Price could be a little better, but we use it to pump river water uphill. Pumps about 500 feet horizontally, with a head (lift) of around 80 feet. Pressure tank holds it steady at around 80 psi when not in use. When in use, setup triggers pump on at around 65 psi, and off at about 80. When using it to run irrigation (about 15 sprinkler heads, around 60 gpm), the pump moves so much water, it will actually cycle the system, instead of constantly running, which is pretty sweet when you consider its max flow is 37 gpm. Read description carefully, as it is a 220v pump, meaning you'll need 2 legs of your single-phase system. At full load, it pulls just under 10 amps (5 amps per leg), meaning you could get away using 14 awg copper (stranded if running through conduit with lots of turns, solid or stranded if using UF wire), but because we were running such a long distance, we opted for 12 awg. Read on if you want to do the install yourself To do it yourself (if you feel electrically inclined), you'll need at least 3 runs of wire, 4 if you want a neutral in the box (not required for this). I usually add a neutral, just in case I ever want to convert it in the future to an outlet or something (using either only 1 of the legs, or using both on separate legs, with common neutral and double pole breaker on the other end). Choose two of the following colors to use as your hot legs: red, blue, black (if adding addt'l runs, use yellow, orange, purple). Next, if running a neutral, you'll need a white wire (for simplicity, we'll skip the banding option), then you'll certainly need a ground, which must be green. Assemble your conduit (you can get away with 1/2 inch (sch. 40), but if it's a long run, I recommend 3/4 inch (sch. 40) (not for underground use, if going underground, use sch. 80 and 3/4 inch pipe). If using UF wire, simply bury it in the trench following depth guidelines. Before filling in all the way, add a line/run of metallic "buried electric line" tape about 8 to 12 inches below the ground. Use wire lubricant when pulling, it makes a difference (trust me). Use a vacuum or similar to "suck" jetline through the pipe (use a grocery bag or similar on the other end). Next, attach mule tape to the jetline and pull that through, or if you're confident you can get it through, using mule tape attached to the bag. You'll attach your wires all bundled and taped to the mule tape, then using lube, you'll pull the wires through the conduit using the mule tape.

great product

Works perfectly

Was very easy to set up and we had it all working in 2 hours . This was a blessing we had been without water for almost a week. We have livestock and had to hall water.