Reseñas de clientes para Elevador de paneles de yeso VEVOR de 11 pies, elevador de paneles de yeso de alta resistencia de 150 libras con brazo telescópico ajustable, ruedas bloqueables, herramientas de elevación de paneles de yeso, ideal para instalación en techos y paredes (amarillo)

De platenlift werk goed en ben tevreden voor de prijs is hij goed. Het doet wat het moet doen en heb er mijn klus mee geklaard.

It works fine for 8’ drywall with the extensions off but the extensions for holding 12’ drywall are not built correctly so the center of the panel won’t press to the ceiling, only the ends touch.

fairly sturdy machine, problem is the lowest setting is shoulder height for a 6 foot tall person. Almost impossible to load the sheet rock that high by yourself without getting injured. Very inconvenient. Still requires two people to load the lift.

Broke on first use

The lift I purchased failed almost immediately. The lift is three major pieces. The panel support drops into the post. At the point the welds completely failed on the 8th panel leaving the entire panel support free to wobble over 40 degrees as measure with a level. Vevor supports solution was to refund $48 and for me to find a local welder to fix the connection point. When I stated this was not an appropriate solution they closed my ticket with no resolution.

think of this as disposable. one time use. Quality is ok but its hard to use. The cable used to wind up the lift does not wind right. Its not aligned with the wheel used to wind it. So you have to pull it to the side to get it to wind

I would like to return it Useless bad design small wheels can't hold the Sheetrock

Cela ne convient pas et je n'arrive pas a le retourner...Pour un remboursement

This lift has all of the features of drywall lifts that I have rented in the past but the mechanism for lifting the drywall is not very sturdy. It is a pulley system that uses a wheel with a handle on it. The wheel hub is not perpendicular to the direction the cable is going so every time the wheel comes around, the bolt that secures the handle interferes with the cable. This is a simple misalignment that stems from the production floor. Whoever is welding these needs to adjust their jig.

To tall for 8ft high ceiling .had to put together,metal on metal won't fit right ,i had to hammer it .unstable for one man working on it