Reseñas de clientes para Elevador magnético VEVOR, capacidad de tracción de 880 lb/400 kg, factor de seguridad de 2,5, neodimio y acero, imán de elevación con liberación, imanes de elevación permanentes, imán resistente para polipastos, grúas de taller, bloques y tableros.

Works well, simple to use and very strong. Handle machining is a bit rough, purely cosmetic and doesn't affect functionality.

Leider rastet der Hebel/Arretierung nicht ein,hatte bisher aber noch keine Muße mich darum zu kümmern. Entweder muss ich ihn zurückschicken oder habe ich etwas falsch gemacht?

The magnet itself works fine, however, moving the handle from off to on is literally impossible without a 3 foot cheater bar. I'm 6 feet tall and 240 pounds...Big construction worker... This thing has so much spring tension on the handle that if you're not super careful and very strong it WILL break your wrist when you disengage the magnet due to the spring tension against the handle stop. I don't know if it's supposed to be so difficult to engage/disengage or not but it takes in excess of 100 pounds of force to actuate the handle back and forth to lock and unlock the magnet. Don't buy this if you're not 100% confident in your strength and ability to use a BIG cheater pipe!

Pésima conpra , no resistente ni 45 kg decepcionado

This item did not work at all and is very unsafe for anyone using it

Hab einen Kleiderständer bekommen

He was not holding 1300 pounds

Been 3 months now and never received item. Package apparently damaged in transit but ZERO communication from any at Vevor, they will gladly take me money and communicate with customer to make it right.

es un elevador magnetico para maximo 600 kg. con piezas de 180kg, ya se suelta el iman. no lo recomiendo.

I don’t think this is capable of lifting the advertised weight. If it can, then I must be using it wrong. I tried several times to lift a plate vertically, and each time the magnet would slide off. The plate is approximately 400lbs. I also tried to lift the plate flat, and it would hold for a moment then let go. To be fair the metal I am lifting has surface rust so perhaps the metal needs to be clean first. I respect its boundaries and it works well when I do that.