Reseñas de clientes para Expansor hidráulico para tubos de escape VEVOR, de 1-5/8" a 4-1/4", 10 T, con 4 matrices y 2 estuches para tubos de cobre y aluminio en la reparación de automóviles.

Works really good just wished it came with both dies even has a place in the box for it . Quality isn't bad for the price .

Buena relación calidad precio, envío en su plazo, bien presentada en su maletín rígido sirve para cuatro medidas de tubo las más utilizadas para hacer tus propias líneas de freno

Buena relación calidad precio, envío en su plazo, bien presentada en su maletín rígido sirve para cuatro medidas de tubo las más utilizadas para hacer tus propias líneas de freno

Great and quick to make piping . Good for a decent fix at home . Made it easy to Quiet down my duramax . Used the 4” it fit together perfectly. Vevor came through yet again.

Wrks gd just make sure you don't f**k up the first time had to recut with supplied cutter wrks ok gd product

I have worked in the exhaust business for many years and have used a few tools made to do the expanding job with an impact or Ratchet. This is one of the few that when used properly does a fantastic job. Its well built and durable and at a very good price. You cant go wrong.

Great tool for the price. My only complaint is the bulkiness of this compared to other hydraulic kits. The inserts are quite large, but it still works good.

This is really good for copper but when using stainless steel it doesn't seem to work really good try to use it on stainless steel and it didn't work too good

I bought this primarily for the double flare feature, specifically the 3/8'' tube size and wanted to use it on stainless steel tube. That said, the first time I used it the 3/8'' tube just pushed right out of the holding die and didn't produce a double flare at all, just a single flare with a small double edge. Frustrated, I tried it again with the tube protruding further from the die, thinking I just hadn't had it tight enough or the tube wasn't far enough forward. Same result, and this time I'd marked the tube and could see how much it had pushed back out of the die. To make a long story shorter, I put the two die halves into my mill and removed .008'' from each mating face and now it works correctly. I didn't think that should have been needed, but it was, at least for the 3/8'' die set. I haven't used any of the other die sets yet so don't know if this is going to be needed on those as well, we'll see. Anyway, all the dies and the corresponding flare mating tools are in the kit, maybe it needs to be fine tuned a bit, but the price is right, the hydraulic part works really easily and I'm happy, lots of stuff you buy nowadays doesn't even work; all the parts are here, it just needs a little finessing.

Good tool with lots of dies. It's a bit awkward to use and not good for tight places, but it will do a very nice repeatable flare. I'm happy with the purchase.