Reseñas de clientes para VEVOR CH-60 - Perforadora hidráulica de 31 dientes, perforadora de fuerza, perforadora suave para placas de hierro, barras de cobre, aluminio y acero inoxidable

Great value easy to use fast delivery recommend quick delivery Great product good selection of punches

Used this CH-60 punch to cut 3/4" holes in guard rail post with 2510A Air/Hydraulic pump. It does a good job snapping holes in 3/16" steel with a nice loud ring. Neighbors a half mile away asked what that popping noise was. With that said...If you use this unmounted (as holding it on its side punching holes in vertical metal) be prepared to use your muscles. At 38.7 pounds it is a substantial weight to hold in position repeatedly. If it were lighter, It would not work have strength to push a steel punch through another piece of steel. Will have a few hundred plugs before finishing. I can use 3/8" punch to turn them into heavy washers. I'm happy with purchase.

I punched 1 1/2” hole thru 3/8” a36 flat bar using a hand pump and it worked great! Time will tell but for $119 can’t pass it up!

Excellent communication, fast delivery. Yes, this company is real! For the price, you can NOT go wrong!! It payed for itself with a profit in the first job

Good tool. Pity Vevor did not sell the punch tooling but nonetheless good tool.

This little guy works like a charm. Punched about 1000 holes the first couple of days upon receiving the tool. This tool is worth the money. I’ve used the 3/8” and 3/4” dies on 1/8” flat bar with no problem. Wish I would’ve bought the foot pedal pump. I recommend this punch tool

Haws. After 2 years in my commercial fab shop it still punches with the original dies. Has paid for itself 100 times over literally! Wish I could find replacement dies for it in different sizes.

This thing is stout. No Regerts! Would like to have larger and smaller dies. It will punch more than 3/8 mild steel. It is quite heavy to move but my neighbors love it just as much as I do. Great addition to any home shop.

Excelente perforadora, la recomiendo ampliamente.

I pushed this thing with a 17/32" square punch. The only way to orient punch is to establish a flat on punch and drill ram for a set screw. The 'snap' of 1/8" A36 has a tendency to loosen the punch retention nut. But, overall. I am pushing the design limits.