Reseñas de clientes para Hervidor de acero inoxidable VEVOR, 16 galones, fondo triple para cerveza, incluye tapa, asa, termómetro, válvula de bola, filtro y bandeja.

Great quality and workmanship and good customer service. Shipping was prompt and as expected. No lmarkings inside pot which makes it a little more difficult for measuring.

The casing looks sturdy. I recommend putting a flat rubber gasket between the metal gasket and the container.

Beware before you buy and make sure you have plenty of PVC tape to secure the spout and temperature gauge. It leaks pretty bad on its own without any support. Works perfectly once I put the tape on.

Ketel van bijna 19 liter is goed te verwarmen ook op inductie kookplaat. De thermometer is eenvoudig te ijken. Punt van aandacht zijn de afdichtingen van afsluitkraan en thermometer.

FIRST Go buy thick teflon tape. Heat water in pan and check for leaks. As soon as it got close to a boil it started a slow drip. Had to tighten the crap out of ball value fitting. The through fitting on the pan itself needs to be as tight as possible. False bottom is way too high. After pan was tilted it left about a pint behind.

This pot is exactly what I was looking for however the bottom opening is defective and it won't seal. The upper one with the thermometer seals fine. I have been trying to contact customer service for 2 days but a message says there are an extreme amount of emails so it won't let me submit it. I would like to exchange it for one that isn't defective as soon as I get ahold of customer service. This pot is well made and should work fine when I get one that isn't defective. I considered finding someone to tig weld it but I shouldn't have to repair a brand new item and customer service should be more accessible.

Material looks weird for stainless steel ... May be mostly build in aluminium

Добрый день. У меня проблемы с фальшдном. Оно не подходит по размеру к кастрюле. Фальшдно больше диаметром и не влезает в кастрюлю. Замените мне его.

It was to hard to put together, seals would not work properly

La cuve est très correcte avec un bon fond. Mais la tôle percée du fond filtrant est de très mauvaise qualité. Elle griffe la cuve lorsqu'on la descend, de plus elle n'est pas assez rigide et s’adapte mal dans le renfoncement circulaire prévu pour la soutenir. Il faudrait une grille plus rigide avec des pieds. En résumé, c'est une bonne cuve pour l’ébullition, mais pas du tout pour l’empâtage.