Reseñas de clientes para VEVOR Horquilla para paletas con enganche de 3 puntos de 2000 libras, accesorio de horquilla para tractor de categoría 1, 25.5\'\'x22\'\'x41\'\', accesorio de acero para equipo pesado de tractor, para

Broke first use - the tab holding the pin for 3pt hitch folded while sliding the forks into a pallet. The original welds didn't penetrate the metal.

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

It work

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I bought my forks about a month ago, when I received the box it was torn up and one of the yellow plates was missing. When I put it on the tractor, one of the screws was cross treaded and extremely hard to tighten. Other that that, quality is awesome and very well made. I would buy them again.

If I had it to do all over I would bought the ones that are connected but I just welded a piece of pipe to mine. They serve there purpose but the will shift one you no matter how tight you get them.

Quality of steel forks are really good but the center likes to pop out sometimes. If they made the center a little more steady it would be pretty good product.

Get what you pay for within a couple days the paint on the forks flaked off peeled off. Tighteners are difficult to work with. If you can afford it by high-end.