Reseñas de clientes para Limpiador ultrasónico VEVOR de 30 l con temporizador y cesta de calentamiento. Máquina de cavitación sónica digital profesional de 360 W para herramientas de laboratorio, piezas metálicas, carburador, latón, piezas de automóvil y piezas de motor.

This is an excellent ultrasonic cleaner. Separate heater and timer controls. Turn it on, set the temperature and wait for it to warm up to temperature; and you are ready to clean.

I pulled the fan, controller and solar panel or of the box, hooked it together and stuck the solar panel on the sun. The fan actually ran faster in direct sun than it did hooked up to regular household power. I don't know how long it will last but it really surprised me at how well it works even in low ( solar ) light.

Great ultrasonic parts cleaner for the price. I’ve used this VEVOR cleaner on several automotive and mechanical parts, and it does an excellent job removing grease, grime, carbon buildup, and dirt from areas that are almost impossible to reach by hand. The heater gets the solution up to temperature nicely, the controls are easy to operate, and the ultrasonic cleaning action works surprisingly well on stubborn buildup. The stainless-steel tank is sturdy and easy to clean when you’re finished. It has saved me a lot of time compared with scrubbing parts by hand. If you work on engines, carburetors, small engine parts, or other mechanical equipment, this is a very handy machine to have in the shop. I’m very satisfied with it and would definitely buy it again

Great unit, cleans amazing, we use it with specific carb cleaner mixed at 5:1. works as it should.

Works great

Unit works great and is a great price for the size of it, I cant believe I waited so long to get one makes cleaning carb parts and engine parts so much easier

So far good

So I recently bought an SLA 3D printer that prints really big parts, and I couldn't find an ultra sonic cleaner whose dimensions matched the parts it printed to clean them before curing, but this ultra sonic cleaner does a great job for it, if you do get this for your 3D printer I highly recommend not using the heat of the ultra sonic cleaner and filling it with denatured alcohol/methylated spirits, does wonders for cleaning prints in like 5 minutes.

So far I have cleaned a couple of carburetors using water and simple green solution. Comes out nice and clean. Rinse with water and blow dry. I have the version with 2 control knobs which I like the simplicity of. Have 4 motorcycle carbs to do yet

This works just fine for the price. I haven't used it extensively yet but so far it has been able to clean everything I put it up against.