Reseñas de clientes para Limpiador ultrasónico VEVOR de 30 l con temporizador y cesta de calentamiento. Máquina de cavitación sónica digital profesional de 360 W para herramientas de laboratorio, piezas metálicas, carburador, latón, piezas de automóvil y piezas de motor.

Ne fonctionnait pas à l’arrivée. Je me suis aperçu que ce n’était qu’un problème de serrage des boutons. Je me suis donc débrouillé seul, maintenant fonctionne parfaitement. Très efficace pour mon usage ( nettoyage de chaines de vélo) Satisfait de mon achat, surtout au vu du coût.

This unit works, its very affordable... but you will need to do your own research on youtube and a bit of trial and error because the information supplied is very thin. My experience has shown me that its best to clean your records with isopropyl to remove any oils from fingerprints first. These cleaners are really for getting into the depths of the grooves to remove hardened dirt, not for oil removal.

Laang leverings tid men er virkelig positiv over ultralyds renseren

So I recently bought an SLA 3D printer that prints really big parts, and I couldn't find an ultra sonic cleaner whose dimensions matched the parts it printed to clean them before curing, but this ultra sonic cleaner does a great job for it, if you do get this for your 3D printer I highly recommend not using the heat of the ultra sonic cleaner and filling it with denatured alcohol/methylated spirits, does wonders for cleaning prints in like 5 minutes.

So far I have cleaned a couple of carburetors using water and simple green solution. Comes out nice and clean. Rinse with water and blow dry. I have the version with 2 control knobs which I like the simplicity of. Have 4 motorcycle carbs to do yet

This works just fine for the price. I haven't used it extensively yet but so far it has been able to clean everything I put it up against.

Distilled water - 5.5 l Isopropyl alcohol (IPA) 99% - 100 ml Kodak Photo-Flo 200 - 15 drops Cleaning time 15 min Cleaning 1. Fill the bath with distilled water. 2. Add IPA and mix 3. Add Photo-Flo 200: 10–20 drops total. 4. Add distilled water to the mark 5. Heat to 30°C (this takes about 40 min) 6. Place the plates in the rotating rack and turn on the ultrasonic cleaning (10–20 min). After ultrasonic cleaning: 1. Rinse the plates with clean distilled water (with a spray bottle over the sink) 2. Place the plates on the drying rack 3. Insert the dry plates into new plastic sleeves

Hello The machine Works very good, but : Why does it Come rust in the bottom ? What can i do to remove this .

I got this for cleaning engine parts works really good just water and degreaser additives, bit loud just make sure you wear ear protection.

Very impressed with the cleaning results. Highly recommended