Reseñas de clientes para Motor de bomba de piscina VEVOR de 0,75 HP, bastidor 56J, 115 V (8 A)/230 V (4 A), 3450 RPM, 60 Hz, factor de servicio 1,5, condensador de 80 μF/250 V, rotación CCW, brida redonda, motor de repuesto

Used this as a replacement for a Pentair Whisperflo pool pump the feeds some pool waterfalls. Easy replacement for the original motor that was on the Whisperflo. There are 3 features that would make this 5-star all around: 1) make the rear motor shaft accessible without removing the rear cover cap (for easier pump seals/o-rings replacement); 2) the rear motor shaft is machined for 10mm wrench vs the standard 1/2" so I need metric as well as imperial to replace the motor; and 3) the electrical connection area is a little tight. None of these are deal breakers though and I've ordered another to have on hand as a backup.

I bought this pump on June of 2024 and is working perfectly, good quality and the price you can’t beat that

Quoted $2800 by our pool guy to change out dead pool pump. The pump itself wasn’t dead, just the motor. So for $130 shipped I had it fixed in 30 minutes! Motor has been running for 7 hours a day on the pool pump/filter for 3 months now no issues!

So far so good. The price was great. The motor was as advertised for a pool pump motor replacement. Quality appears to be good but only time will tell. The only challenge was installing the leads with lugs already installed. With a flex connector installed there is very little space to get leads through due to location of a board inside the motor. It probably would have taken less time to install if I would have cut the lugs off before running the leads. Otherwise, I would buy again if it is shown to be reliable.

Very happy with the motor , it’s working perfectly . Arrived in very good condition, very well packed with very good condition.

The motor is direct replacement for Century 1.5hp 56y frame used on Hayward pool pumps. Very easy bolt together project. A few reviewers complained about wiring connections but while rather tight it was easy enough by using spade connectors on my wiring. Some also complained the motor is noisy but I think those people are hearing more pump noise than motor noise. The sound from motor is normal electric motor hum, the bearing are relatively quiet. All said this motor is a good value

The motor came in quickly. Very good and quiet pump. It was easy to install. Perfect replacement motor for hayward super pump.

Works well. Actually like the design better than some of the oem manufacturers. It’s a slow start. Instead of hard on/off. Was only running in a Hayward pump for a couple mo the before winterizing bit so far running well.

The only time spend on it is its marketing picture, which says the shaft including threaded portion was 47mm that is NOT the case. After contacted the technical support got a technical drawing to verify that the shaft excluding threaded portion is 47mm. The I ordered the product, it arrived as promised. Installation with a instruction booklet is very smooth, and runs fine for over a month.

Motor came in quickly. Packaged very well. Perfect replacement motor for hayward super pump. Swapped motor and replaced all seals and back up and and running. Took a total of less than an hour. This may actually be the quietest motor we have had so far. I would highly recommend this motor. As for longevity, time will tell....