Reseñas de clientes para Motosierra de gasolina VEVOR de 52 cc, 18" y 2,55 HP. Motosierra de gasolina inalámbrica de mano para cortar ramas de árboles, podar árboles, limpiar terrenos y talar bosques en granjas, jardines y ranchos.

Fuel tank, casing leaks fuel odors, leaving fuel / odors at unwanted places.

So far only one complaint and that is they don’t make replacement bars or upgrad bars. You can find bars that fit and work for it but I couldn’t find one from VEVOR . I have used it a bit safe to say I have bucked up over a cord and used it on a few other small projects. Runs great starts fine all the time. The kill switch stopped working so I just choke it to kill it.

So I was having high hopes for this saw. I have purchased the Vevor backpack leafblower and have had no problems with it. I purchased new 100% gas and a can of oil. Filled leaf blower and the New Vevor chainsaw. Started on 5-6 pull! Awesome. Ran saw like they said, half throttle first 15 or so cuts. Set it down. Start piling limbs. Go to start it, won't start. Finally get it started with choke on and go to cut and it would die. Pulled the plug out and checked it. Its clean. Check air filter it's good. Go to top it off with gas and notice big puddle of oil on the concrete. Top both of them off still doing same thing. Went to get the saw off the ground and my wife says "is that thing spraying gas out around the fuel cap"? Yep, sure enough. I've reached out to Vevor and the response I got was 1. You need to make sure it's got gas in it! 2. This chainsaw has an automatic oiler and is customary for it to leak a little. So, I did buy the extended warranty for this and all I get from them so far is "you got gas in it"? Y'all take this with a grain of salt. Hopefully they will refund or replace this thing. If not I'll go buy a Sthil. Tried to upload pics and videos but it won't upload.

So the saw c is kinda heavy, the price and time it took to get here were amazing. I followed the instructions impeccably, then it just would not work

Chain broke before it ever touched wood and no it was not too tight. Bought Oregon chain and it worked great.

The handle on my chainsaw come apart today I've only used it three times I'm disappointed in it.

De piètre qualité ,quand on installe la chaîne, les pièces en mauvais plastique rigide ne s'emboîtent plus . On recommence et s'est pareil. Du coup on hésite à s'en servir. Qd on coupe du bois avec ,elle fonctionne bien

Started leaking bar oil immediately

Thank you for good service so far. For preparing the saw before use, some screws had to be tighten properly. After that the mounting went good. I have tried the saw, and have some comments. Easy to start, but it’s recommended to put som chain oil on the chain before starting. When sawing, the chain became too slack and needed to be tighten up. This happened tree times on a job that took around half an hour. The screws for attaching the chain sword were properly tightened each time. This I consider as a safety risk if the chain goes off when sawing. I am not sure how to fix this. In general, the saw were cutting fine, but I have not used it long enough for a proper judgment yet. BR.

Fait son travail un peu lourde