Reseñas de clientes para Motosierra de gasolina VEVOR de 25,4 cc, 12" y 1,2 HP. Motosierra de gasolina inalámbrica de mano para cortar ramas de árboles, podar árboles, limpiar terrenos y talar bosques en granjas, jardines y ranchos.

La motosierra se atasca con ramas finas y desmonta la cadena, o bloquea su giro de cadena.. Mala motosierra, mala compra, tengo otra motosierra de otra marca y con esa, tendré que hacer el trabajo.

The saw is only good for trimming small branches. I used it twice and it broke twice. It runs great and is light weight. You cannot cut anything bigger than 3” because if it pinches at all and you pull on the saw, the handle breaks loose. The saw then has to be torn apart to put it together again. The second time the screw pulled out of the plastic and I had to drill it out and bolt through it. Next time I figure it will break the housing and I will have to throw the saw away.

Won't rev up, won't restart after refilling with fuel. Local small engine shop said that the high adjustment is stripped/ bent so it will not hold position. Customer service is a hassle, requesting a picture. Not sure how someone would photograph such a problem.

Hello both the small one don't work the pull cord will not wrap back up so who around my area works on them or use my warranty and send me two new ones please , I have bought a lot from y'all

first time i used ,it worked ok , second time i bent the chain and now wont track on bar.

The bolts holding the bar to the body came off.

Struggling to get this to start, based on other reviews I’m sure it’s a fluke. Once it starts it runs fine but starting initially is a task

De piètre qualité ,quand on installe la chaîne, les pièces en mauvais plastique rigide ne s'emboîtent plus . On recommence et s'est pareil. Du coup on hésite à s'en servir. Qd on coupe du bois avec ,elle fonctionne bien

Leaks fuel, when running and in storage, serious safety hazard. it only cost me $100 lesson learned to never buy from vevor again

Thank you for good service so far. For preparing the saw before use, some screws had to be tighten properly. After that the mounting went good. I have tried the saw, and have some comments. Easy to start, but it’s recommended to put som chain oil on the chain before starting. When sawing, the chain became too slack and needed to be tighten up. This happened tree times on a job that took around half an hour. The screws for attaching the chain sword were properly tightened each time. This I consider as a safety risk if the chain goes off when sawing. I am not sure how to fix this. In general, the saw were cutting fine, but I have not used it long enough for a proper judgment yet. BR.