Reseñas de clientes para Placa de montaje VEVOR de 1/4" para minicargadoras, placa de montaje universal de conexión rápida, fácil de atornillar, capacidad de carga de 1500 lb, placas de carga de acero de alta resistencia compatibles con minicargadoras y tractores Toro Dingo

Fit nice on my tractor. Great finish!!

Very well made and heavy duty. Only downfall my hydraulic locks didn’t lock I needed to take some material out.

I used this plate to build a snowplow mount for an old side by side plow for use on a Kubota SCL1000. Though the plate fit and locked onto the attachment mount, it was very loose. I had to cut some shims out of bent angle iron to make the mount tight. For less than fifty bucks I can't really complain. It got the job done, the steel seems to be of good quality and it was easy to weld on.

Nice quality but the quick attachment pin slots do not line up had to modify slots for the locking pins to engage the quick attach plate other than that works great

Price was right, fit, although there is a bit of side to side slop. Its not really a fault of the SSQA, i bought the 1/4", and i paid for the 1/4"; but its thin and somewhat flexible for my use (mounting somw bucket forks to the ssqa plate). Probably should have gone 3/8". Would i buy again, yes, if your specific use case can use a 1/4" plate. If unsure, id go 3/8"

It's well made and hard to beat for the price but I felt the dimensions are a little off. It is loose (a bit) once on the quick attach receiver. I have been able to use the equipment without issues however, so I guess it's just me nitpicking, but I don't like seeing it have this much play. I'm making my own and measurements picked up online are confirming that this one is a little too big on the vertical. Again, not a huge issue as it works.

One major problem with this product was its advertised as 1/2 inch when it actually 3/8 of an inch The coatings are nice the OK but just

You know I’m slightly annoyed. I had high hopes for this. The quality is not the problem. It’s actually pretty good and worth it. But the dimensions were incorrectly built on height. Width at 24” is fine. Because it’s approximately 1 inch over dimension on the face mounting, the locks on the bottom side do not engage nor does it fit correctly. I’ve tried to mitigate this with various temporary methods to no avail. I have five attachments that fit the skid steer and they all have no issues. So I can only assume this one is just built over dimension by 1 inch. Eventually, I’ll make it work so not returning it as I’ve already modified it First photo is OEM. Next two photos are of Vevor product. I suspect as a welder if you ran a couple of beads on the inside top pocket. It would be fine. That’s what I’ll be doing.

I welded a set of forks on this plate. The hole for the bottom latch was really lose and I had to weld a plate to keep it from bouncing. I hit a stump with the bottom of the plate and the entire plate bent in. So bad that the forks cat be used anymore. It is 1/4" thick so I know it has limitations but it didnt think they would be this.

Too big for a standard skid steer plate but with a bit of modification it should work fine.