Reseñas de clientes para Sistema de agua desionizada VEVOR para lavado de autos, sistema de agua para lavado de autos impecable con 2 resinas DI de 4 L y medidor de TDS, filtro desionizador de agua portátil y sin contacto para autos, vehículos recreativos, motocicletas y ventanas.

No Spots!

The seals they provide for the fittings are incorrect and they do not make or sell the correct fittings. If you go and find and purchase the fittings and seals for the unit it works great.

The unit worked well and produced spot free water. However, as others have stated, the quality of the brass quick connect fittings are terrible. The quick connect hose coupling leaked and the two piece swivel female hose connector broke apart when trying to get it to stop leaking. I worked for over an hour to try to get all of the brass fittings to stop leaking and finally gave up.

Ok I didn't expect it to be massive! This thing is almost the size of a scuba tank but wider. Comes nicely packed and almost ready to. Install the fittings on both side and don't forget to put the handle on. Connected to a water hose and open the water flow really low as it's recommended for max flow of 3 gpm. Let it flow for 5 minutes and then checked the TDS and was surprised to see 0 TDS. I got the unit with the bypass valve and the manual doesn't say anything about some other stops on the valve like backwash and quick rinse but I put the valve on those setting and it didn't flow any water so I assume that it's just bypass and filtered. Remenber to use the bypass setting for washing the car and initial rinse, after that switch the valve to rinse for the final rinse and your filter will last you a longer time!

Works well for me. No leaks. Satisfied with this product.

Pulled my water from 219ppm to 0.00ppm in my detail shop...leaving no water spots!!!

After assembly I checked for water leaks. Ran water through at a very slow rate in bypass mode. Turned valves to non bypass at same slow flow rate and ran for about 2 minutes. I disconnected my hoses and let the resin soak for a few days. My water tester registered a TDS of 211 ppm on the input flow side. Before the soak, I was getting an TDS of 25ppm in non bypass mode. After the soak, I am getting a TDS of 0 ppm on my tester and on the onboard TDS meter in non bypass mode. The unit is working very well.

Easy to use and works flawlessly! Had a small issue with my handle breaking, but it was quickly resolved with their support team! Highly recommend!

Life changing

I have a well.at my house and always get water spots when I wash my cars. This worked great, no spots from final rinse. The quality of the fittings could use improvements, the coupling leaked and broke apart. No screws to mount the handles. Over all I would still recommend it, just plan to buy fittings on tour own.