Reseñas de clientes para Válvula hidráulica VEVOR de 2 carretes, válvula de control de joystick hidráulico de 11 gpm, válvula de control direccional hidráulico de doble efecto para tractores, cargadoras y tanques.

I bought this valve to put on my tractor to do away with the 2 lever valve that was on it .the price was amazing and the quality and performance is awesome I've had it on my tractor for a year now and best choice by far.

This valve arrived with no instructions and proper port identification. I bought the valve to replace the one on my Kubota tractor for the loader. As such I also needed the Power Beyond capability. Thanks to the previous reviews I was able to figure out what was needed to have the valve operate properly. Using the 1/4' NPT plug to block the small port inside the valve at the PB port location did the trick. Photos are attached to help clarify what was done.

Seems like a lot of other comments say the thread is British or O ring boss #8 or half inch I’ve found my valve to be national pipe thread… what ever just change the fittings

Fittings were neither SAE or Metric. Never heard of British fittings before. Cost me an additional $250.

Great value for it's price. The review from 'medammit' below is incorrect: This valve DOES have power-beyond capability. And even better: It uses the old style of power beyond isolation, where you screw in a 1/4" pipe plug into a galley port inside the spare outlet - unlike most modern valves that require a special (and expensive) adapter sleeve for the power beyond port. The power beyond port on this valve is one of the tank ports on the side that's capped off from the factory, with the drilling for the galley plug located down inside it. There are two additional tank ports (side & top), so lot still some flexibility where your tank port runs to. The galley plug is 'technically' threaded 1/4" BSP, and a plug this size might be a little awkward to find. The pitch of 1/4" NPT is so similar to BSP that I used a more common 1/4 NPT plug instead and it worked just fine. You probably need a plug that has a female socket drive (hex/allen-key, or female square), because a plug with a square male drive end will probably interfere with the PB hose connection (maybe not - the hose might slip around the square, but I didn't try it so I don't know). The only unfortunate thing about this is the 1/2" BSP ports, which are a little unusual over here in North America. If (like me) you're getting new hoses made and your hose supplier has BSP ends, it's not so bad. But if you're planning to re-use existing hoses with ORB or NPT ends, by the time you buy enough adapter fittings you could probably have bought another valve with more common ports. The relief valve on this was set unusually high - worth checking and adjusting for your application.

Les connecteurs ne sont pas standards

Used to control 3 point stump grinder

No manual instruction....... ...........................................................................................................................................................................................................................................................................................

Unusable, the threads are too large to fit new fittings. Poor machining on both the valve and new fittings I bought elsewhere. Old fittings on the VEVOR valve fit ok and the new fittings fit ok on the old valve, but between poor machining on both the new valve and the new fittings meant I had an unusable setup. I'll have to return this item.

The valve’s pressure adjusting system isn’t working. It started to leak and the adjustment screw which was a cheap, low carbon steel stripped off in just a few rounds of adjustment. Let alone it kept leaking from adjustment screw. Tightening it would just stripped it. Took me 6 hours to cut to length, install the hose fittings etc and all went down the drain.