Reseñas de clientes para Ventilador extractor de pared VEVOR de 91 cm (36 pulgadas) con persianas automáticas, color plata, carcasa de acero resistente, bajo nivel de ruido, motor de CA, 9761 CFM de ventilación y refrigeración para ático, garaje, granero, invernadero y taller.

Works as advertised

It comes bare wire, you'll need a plug end or terminal box. Moves enough air to keep the upper story from heating up where it used to be consistently hotter than outdoors, sometimes now I need to shut the other fan off to be comfortable when the night or morning air is too cool. I plugged it in to a drop light extension cord for now, with a plan to add thermostatic control and hardwire it.

The fan was very easy to install. I used the front packing cardboard as a template, and powered the unit through an outlet with a thermostatic switch plugged into it.

Bought in mid July, installed it in my chicken coop. Works great and flock is thankful

J aurais bien aimé avoir les instructions en français

I put this in my shed to keep my battery temps down a bit and was surprised to see a 10-15+*F drop just by circulating air through there. I do have some poor man insulation throughout the shed so I am sure that helps but the fan is doing the work and making the biggest difference. Way better than just the normal vents without a fan. On my solar battery it uses 20 watts and I have set to kick on only at 83F. Seems more sensitive than another temp control panel. Not sure which is more accurate. Note the auto on function beside to set the other auto functions way outside a reasonable limit so the fan isn’t triggered based on something else than what you set it for but it is useful if you wanted it to kick on for 4 different modes it will H/L temp H/L humidity. I only use high temp

Exhaust fans works perfectly! Mounted in gable of pole barn drops temp about ten degrees in just a matter of minutes. Highly recommend!

Very good quality interested 🙏🙏

Works exactly as needed! The instructions are a little difficult to follow. The fan turns on at a certain temperature and/or humidity. Couldn’t use the louvres due to the current design of the fan, but works really well!

Works good for pulling heat out of a pole barn. The only thing I don’t like is sometimes when it shut off at the temperature it’s set at it continues to run slowly and you have to cycle power to it to reset it.