Reseñas de clientes para Mordaza VEVOR ACCU Lock de 6'' para precisión, mordaza de fresado con mandíbula de 6 pulgadas para taladro de columna, fresadora y taladro de banco.

The 5inch vice arrived promptly and surprisingly undamaged given it's weight. Unpacking it I noticed immediately that the finishing was not great but 20 minutes with files took off the sharp edges. Out of the box the jaws aligned well and the action was smooth bit I felt that there were some small modifications that would make it better. Firstly I didn't like how the lock collar just screwed onto the threads so I made a brass split collar to replace it. Also the bearing surface for the back of the lead screw had not been machined and caused a little binding. I used a dremel tool to flatten this and then added thrust bearings on both front and back surfaces to make it easier to use. Overall this product is, with a little TLC, value for money.

Very good price over quality. Arrived fast, well pakaging. It is heavy enough in order to give that stbility without vibration we are all looking for.

It will do the job, But first there's a lot of work to be done. You must tear it all apart, every bit and scrub the hell out of it to get the cosmoline packing grease off of it. After a few hours of that break out the files and take all of the sharp edges off. And after a few more hours of that you need to oil and grease the lead screw and thrust bearings, then after that you get to start lapping the swivel base to true up the mating surfaces before you can think of bolting to your mill table. My time is money, and I'm invested deep before I can even use it. Yes after all of that it's a damn good mill vise.

Bon produit, dommage qu'il ait reçu un choc, heureusement au niveau de l'hexagone de la poignée, un coup de lime devrait régler le problème

For this money it’s worth the buy

Muito bom para o fim a que se destina ..

For the price it's tough to go wrong with these. Was easy enough to measure and make some soft jaws.

Good value good quality. You need to adjust the Jaws to true parallel. Easy to do slacken Allen bolts and set to parallel with milling table

Good for the money. Finishing is mediocre but the action seems accurate and squareness is adequate for hobby machining use. Arrived without damage.

Comme toutes mes commandes passées auprès de ce site, celle ci a été livrée très rapidement. Je n'ai mis que 4 étoiles aux rubriques : Qualité et Facile à utiliser, car le repère angulaire et l'usinage correspondant sur l'étau n'étaient pas réalisés. Sinon l'étau semble de bonne qualité à éprouver dans le temps.