Reseñas de clientes para VEVOR Barra de Dientes para Cucharón de Tractor 1300 mm Barra de 7 Dientes para Cargador Tractor Compacto Carga de 2000 kg Atornillada para Excavación Eficiente del Suelo y Protección del Cucharón

Definitely I must have for a tractor that has a smooth cutting edge. Totally game changer from breaking up the Earth. I put it on a 32 hp tractor and it broke up old stone in the driveway, and graded down some land that I needed done around the house. I don’t really like the set screws because they get full of dirt, but if you take a piece of tape and shove in the hole, then you have no problem pulling the tape out and get your wrench into the set screw to take the teeth off. my bucket had holes already in it of course, the flat bar holes did not match up so I had to drill new holes in the tooth bar, which is not a big deal if you are familiar with hand tools. All in all I say get it, you will not regret it. And the quality of the product seems very well. Vevor does not have replaceable teeth, but you can find them online. There is a part number on the tooth.

This teeth digging bar works Great. Very strong and successful.

I welded it on,,it is as strong as anything made for 1000 dollars,my bolt holes didn't line up ,but I would rather weld it anyways because I am rough on my buckets

Works great for loosening dirt. Easy to install and remove. I plan to use it to build a small pond with my tractor.

I've used and abused these. No issue with them falling off. Just get them good and tight. Perfect fit for my bucket.

I decided to weld it to the bucket and this monster really performs. It is well built and in doings so was able to take a big load off of the tractor by simply plucking trees and brush out of our grove. reduced time by 60 70 percent vs.. a smooth blade,

Great product and affordable. I have a mid-sized tractor and trying to dig and level parts of my yard was nearly impossible due to how hard the ground is. Added these teeth has made the difference!

Nice piece of hardware for my tractor. Nice piece of hardware for my tractor. Nice piece of hardware for my tractor.

I have an older skid steer with a bucket that never had teeth on it. After a lot of searching I found these bolt on teeth. They are well constructed, and did the job after I figured out what to do with them. And here it the reason why I took off one star for ease of use: The documentation. Yikes. Let's not mince our words on who is buying something like this from Vevor: People who are not deeply into the world of heavy equipment. People like myself may need a very straightforward explanation on how something like this *should* be attached to your bucket. Of course, once I figured it out, it is obvious. However, the following bit of verbiage could have saved me a bit of figuring time. "These teeth can be attached one of two ways. By tightening down the hex key set screws you can attach it temporarily. However, if you would like to have a more permanent attachement, drill holes in the blade and use the included bolts" There we go. When written out, it is obvious. Otherwise, the quality seems quite nice for a generic add on attachment, and I feel I will get a lot of use of it. A recommendation for you is if you are going to use the hex key set screws, I would recommend drilling very shallow partial holes where the keys will seat in your blade. This will prevent them from sliding off during something that pulls back.

Well made, Great price. The holes didn't line up with my Bobcat bucket, but it could have been easy enough to drill out the tooth bar to match. I plug welded it instead through the mounting holes and stitch welded it to the bucket. The quality of the bar gave me confidence enough to just permanently attach it.