Reseñas de clientes para Extractor de fluidos VEVOR, capacidad de 9,5 L, bomba extractora de aceite manual por vacío con manguera larga de 59 pulgadas y tres tubos de extensión de 47 pulgadas, bomba de cambio de aceite con tanque de HDPE para automóviles, cortadoras de césped, barcos y motocicletas.

Never got my order’ delivered. I got a lot of orders from them but I’m disappointed I done with them. I can’t get a answer from them and a refund.

Too stiff to pump and hard to pump extract too. Would not recommend

Nach 2 mal benutzen undicht.

Barrel was ovalized and syringe sticks needs huge amount of force to use. Vevor support unhelpful and refused to remedy.

The kit states that it has filler adapter for nissan transmissions. None of the adapters fit on my 7-speed nissan armada transmission. My vehicle is now sitting on my driveway with no way for me to refill the transmission!!

Tried using it for the sole purpose it was purchased and tbh I am left bitterly dissapointed! Trying to replace differential oil and it fails to successfully fill the pump at all. Stop valve open and pulling with such force that Im terrified it'll release pressure and I'll knock myself unconscious. A $5 cheap nasty temu item does a better job just needs 20x the use due to smaller volumes

I used the medium tube first and only got internal engine smells. Switched to the smallest tube and finally got it down into the oil and only got about three or four liters after an hour or more of frequent pumping. The oil was warm but it was coming out so slowly. After a while I wasn’t sure if it were even in the oil any more. I would return it and exchange it for a pneumatic extractor instead if I could. Even then I’m not sure it would work well. BTW I have a 5.3 V8. I don’t think there is actually a straight/direct path to the oil in the 5.3 V8 through the dip stick tube.

Très bien sauf l embout pour clipser les tuyaux au bout qui n' est pas terribles

Graduation complètement fausse ! Pour un produit destiné à du " remplissage" ou autre, ne pas pouvoir ce servir de la graduation pour la contenance est bien dommage... Ou grave ...

I tried to extract the oil from a 160cc Honda engine. The tubes provided all have the same outside diameter. The hose I used did get into the crankcase through the dipstick opening, but was difficult to get it in. Then when I went to extract the oil I barely got any oil out after 2 attempts. I finally had to tip the mower over to drain the oil, which defeats the purpose of getting this. I've asked for a refund and will return it. I did purchase the 9L unit at a great price this morning to replace it. As you can see from the pictures, the oil barely made it into the container. There was about 18 ounces of oil in the engine, after 2 complete pulls (which were difficult) I got, at best 8 ounces out. Not too impressed.