Reseñas de clientes para Cortadora de papel VEVOR de 30 cm, tamaño A4, comercial, resistente, 300 hojas, dureza 45HRC, base metálica, para escritorio, para el hogar y la oficina (A4)

Tout s'est très bien passé au début, coupe droite pas de soucis. Après avoir fait à peu près 200 découpe de papier 160 gr feuille à feuille, la lame semble émoussée, elle ne coupe plus sur toute la longueur mais déchire à certains endroits, et que dire de la tenue de la feuille, à chaque découpe la feuille n'est plus tenue (est-ce que c'est à cause de lame???) la feuille se déforme à chaque découpe, je fais des découpe pour un client et je me retrouve avec des feuilles déformée pas top au niveau de la qualité.

The blade detached within 3 months of occasional use. Never used it on over 250 pages, because that was when it started getting too hard to use. Used it less than 10 times a month. To get a replacement, I would’ve had to find a box big and strong enough to support it and take it to FedEx. Not feasible when you no longer have the original box and don’t own a car. This cutter is too big and heavy for one person to maneuver.

Bought this to get clean, straight cuts, but I’m finding the cut line tends to drift slightly on an angle even though the edge looks straight. The clamp/holder also doesn’t feel strong enough to keep the paper firmly in place, so the stack can shift during the cut. Could be user technique on my end, but so far I haven’t been able to get consistently straight edges.

Affordable but not the best quality. Hard tonget clean straigt lines.

It’s an ok cutter

It came without instructions. That’s it. Period.

When using the straight edge on the top of the cutter, it's not a straight cut. Slightly off when using

Hi I try to use the cutter that I bought but unfortunately it didn't cut straight all the cuts i get is slightly wavy. Can I return it? Sorry I can't upload more photos In trying but it only accepts one.

Not working properly after just 2 uses. It now pulls the stacks of paper inward puckering it against the metal board and it is leaving a .25 inch chunk eaten out of my chipboard that falls in the path of where the blade comes out. It is not a quality cutter if it doesn't work after 2 uses. I submitted a help ticket and it has now been 3 plus days with no solutions to the problem, requesting a refund. I would love to buy a stack cutter that actually works.

Bom dia, A guilhotina não tem um corte uniforme, quando se colocam mais de 10 folhas, apenas corta nas laterais, com 1 ou 2 folhas nem corta :( Gostaria de saber se podem resolver o problema ou se podem substituir por uma que corte. Obrigado, José Simões