Reseñas de clientes para Destilador de alcohol VEVOR de 5 galones, de acero inoxidable, con tubo de cobre, termómetro y bomba de agua integrados, kit de elaboración de cerveza casera con barril doble, ideal para whisky, vino y brandy.

Very good steel for the entry-level user Thumper needs to be modified In order to be a real thumper just need to add a little downpipe really easy fix

It works great , low priced and a great learner unit. For the small time personal user it is a good investment.

Overall for the price a good starter unit. It would have been 5 star save a couple fairly minor things if you are handy. The "thumper" keg or pot, the intake lid connection needs to extend about 2/3 the way to the bottom of the thumper pot. Get a copper 3/8 to 1/2 tube fitting and a length of straight 3/8 copper tube put it together and it will friction fit to the intake fitting on the underside of the thumper keg lid (the tube is meant to extend into the liquid you put in the keg and heat it). In essence a second distillation. Second issue was the main pot thermometer seems to build up with a sooty deposit that can leak into your boil and the thumper lid connections also get deposits potentially damaging quality once you start refining for flavours. I suggest replacing the stainless tubes with copper and replace the lid fittings as you refine your craft.

Works fine, but thumper seal is to small so on a proper run it will leak alcohol vapour which is dangerous and you'll lose out on distilled alcohol, a small thing i assume will be corrected by after sales

For the price you can't beat it. I've already done five runs and it works well. The one drawback is the flex line & pressure fittings. Expect to plug some leaks during still runs. Also, the silicone seals provided have already started to show wear, but like I said, can't beat it for the price. This is a great introduction still to get started. I will be moving on to a larger and higher grade still very soon.

The boiler works great, but the thumper pot is too small, it is more of a slobber pot. The condenser pot and condenser are too small as well. I went to a hardware store, picked up 10 ft of 10mm ID copper tubing ($10) to make a proper condenser ( 8 coils 130 mm in diameter) then I have it running through a 10 liter pot. For the thumper pot I'm using a 5 liter sealed pot with a copper tube coming from the boiler through the thumper pot lid straight down to the bottom of it. The set up is much more efficient now with no where near as much loss as the original set up. In all I spent an extra $30 CND to make a far more efficient still. Would I buy it again... Sure, but I'd say VEVOR should consider upgrading the condenser and thumper pots to a larger size than the 1.5 liter pots they supply.

This product came to me with the condenser coil requiring a bend that it not have as of yet as I have not found means. Otherwise I can not use this device as no useable condenser was supplied. Proper connection as in instruction is not possible.

One of the hoses was dented. When I straightened it, it cracked. The lid gasket came with a nick in it. Steam comes out. I'm looking for replacement parts

Thermometer was defective and I had to replace it with one from another company, and the air lock bubbler was broken out of the box, but Vevor did refund a part of the cost of the still due to it. It does distill as advertised and for the price it will get you started, so if your looking to just dip your toe in distilling to see if its a hobby for you or not this might be a good place to start.

Never used it as one of the latches fell off during assembly and now there is no way to lock lid in place