Reseñas de clientes para Elevador magnético VEVOR, capacidad de tracción de 660 lb/300 kg, factor de seguridad de 2,5, neodimio y acero, imán de elevación con liberación, imanes de elevación permanentes, imán resistente para polipastos, grúas de taller, bloques, tableros

He was not holding 1300 pounds

Been 3 months now and never received item. Package apparently damaged in transit but ZERO communication from any at Vevor, they will gladly take me money and communicate with customer to make it right.

es un elevador magnetico para maximo 600 kg. con piezas de 180kg, ya se suelta el iman. no lo recomiendo.

These magnetic metal sheet pickups work well for sheet thickness of >4mm anything under 4mm doesn't tend to stick properly, and will slip and fall. So the 300Kg is a little misleading, you can not pick up material less than 4mm ... please be aware of this point

I don’t think this is capable of lifting the advertised weight. If it can, then I must be using it wrong. I tried several times to lift a plate vertically, and each time the magnet would slide off. The plate is approximately 400lbs. I also tried to lift the plate flat, and it would hold for a moment then let go. To be fair the metal I am lifting has surface rust so perhaps the metal needs to be clean first. I respect its boundaries and it works well when I do that.

Om eerlijk te zijn vertrouw ik deze magneet niet. Het metaal MOET 100% PROPER zijn anders werkt het niet betrouwbaar. Ik wou ze gebruiken om metaal platen van 2 vierkante meter 10mm dik op mijn cnc te plaatsen. Nu gebruik ik de magneet om rest plaat van de cnc te halen, geen volle plaat. Bij 5mm plaat ben ik geruster qua draagkracht. 2mm werkt niet echt goed, plaat buigt teveel door waardoor de magneet faalt. Dus 600 kg kan deze volgens mij niet dragen. Jammer wel, had er meer van verwacht.

I bought this for my small metal working shop to help me move thin gauge sheet steel. I won’t hold anywhere near the stated capacity. It can’t even hold a single sheet of 16ga steel which is around 80lb. I’ve cleaned the magnetic surfaces and wiped down the steel surface too. It consistently drops the sheet every time. There is probably a disclaimer somewhere or some highly limited test protocol used VEVOR can fall back on to say the rating is okay/correct, but for regular every shop purposes, the max is probably around 75lbs in real life.

Acheté pour lever du bac acier il ne fonctionne pas. Très déçu

This is the worst product i have ordered from Vevor. I have ordered many different products and most are good, but this one was a total waste of money. It simply doesn't work well, and is hard to use. Would never buy this again or recommend it to anyone.

Lucky to lift 9kg definitely not 90kg bought it for lifting individual sheets of colourbond but it’s to week to even do that..