Reseñas de clientes para VEVOR Extractor de miel eléctrico, extractor de miel de 2/4 marcos, extracción de apicultura de acero inoxidable, equipo de centrífuga apiario con soporte ajustable en altura, tambor de panal con tapa

macht was sie soll... für den Preis eine gute Entscheidung... der Korb iss bissel eng für DNM naja alles in allem besser so als Handkurbel ! ;-) wenn der verbaute Motor mal den Geist aufgeben sollte .... im Internet gibt es nen baugleichen 250W Motor... dann dreht sie sicher mal viel schneller

Alles da, Edelstahlkörper, Verbindungen mit Gewindenieten, Schutzsvhalter, alles billig, aber dafür sauber verarbeitet. Ich bezweifle allerdings, dass die Honigschleuder bei häufigem Gebrauch lange hält. Eine kleine Unwucht bringt die dünnen Beine und die Schraubverbingungen rasch an Belastungsgrenzen Für Hobbyimker grade mal si ok...

livraison rapide montage facile cet appareil fait le boulot rien à reprocher

Manque un peu de puissance quand les cadres sont très remplis et le couvercle est un peu galère à démonter (devoir bien cadrer les trous avec les tiges, nécessite d'être 2 ou de galérer un peu). Sinon fait le job pour le prix ! On ne peut en mettre que 4 finalement, car 8, ils ont tendance à tomber

Les pieds de soutien de l'extracteur meriteraent d'être consolider (trop souple). L' espace pour sortir les cadres de l' extracteur est réduit ( manque de place)

First time beekeeper. Assembly was easy. Very user friendly. Wish the spout didn’t sit up off the bottom so all the honey could flow out but seems to be a common design flaw among extractors.

This is the second honey extractor I have purchased from Vevor. I am very happy with both of them and highly recommend this item.

Works as it is supposed to. This is the only extractor that I’ve ever used, so I can’t compare it to the more expensive ones. I’m sure it is not as heavy duty as those. But for the hobbyist like myself with only a few hives, it works great. Everything is stainless steel so the only part that could possibly go bad is the motor. Which I could easily replace . I’ve had it for a couple of seasons now and it still works perfectly

This spinner worked great. There are very sharp edges that I did cut myself on during assembly so I put gloves on. A pipe deburring tool took care of those. The clear lid is nice but the safety tab on them was too close so it required modification so the lid would close properly. To disassemble the unit you have to remove the 2 bolts holing the motor assembly on. I replace them with hand knobs to make it easier. That would be a nice modification from factory instead of the cap nuts. Overall good value requiring minor modifications to last a lifetime.

This worked just as it should have. It was easy to put together and I ran 20 frames through it and had no issues. I did secure it to a large board to give it stability.