Reseñas de clientes para Gato hidráulico/neumático de brazo largo VEVOR, capacidad de 8 toneladas/17363 libras, con bomba de pistón simple y base de horquilla, elevador manual con asa, para grúas de taller/garaje, elevador de motor, rojo

I wanted to replace the original Ram Jack because it was not holding the arm up but I wanted this one because it has a pneumatic pump to it. I can use my air hose to it and then manually pump the jack up to fine-tune the arm.

Works great! And quick shipping to Europe!---------------------------------------------------------------------------------------------------------------

If you have a cherry picker you have to have this. One man operation Is way more easy with this! I’ve looked at a few of these and this was the most reasonable. Smooth and controllable.

Recently i bought an 8T jack for pipe bending project i will recommend this product because has a good price and fast delivery, heavy duty item. Thank you

The ram works great. I built a lift table using it. I wasn't sure it would work in a horizontally position but it does. It seems to have plenty of power. It will lift a riding lawn mower.

Very nice construction, Fits perfectly for my engine hoist, Comes with a handle to operate, Seems to lift complete cast iron V-8 auto engines attatched to a trans with no issues, Packaged very well / no shipping damage, efficient and reliable shipping service, very Reasonable Price,.I'd buy it again.

This jack is really a good buy and a good product. It does what it is described to do and it works well for an affordable price. Hopefully it would last a long time. I have no negative remarks about it.

Works as it should. Doesn’t hold the load. Drifts down within an hour. The air cylinder stopped working after the second lift cycle. Overall would recommend

Only issue was resolved a day later was my only complaint but took care of the issue made it right vevor looks out for there customers

These cylinders are great up until they are almost at the top of their stroke. They can handle the 8 tons they are rated for but not at the top of stroke, the last few inches the shaft and the outer casing are able to tilt so they are not inline and this causes large sideways forces . In my application we were at 6 tons for this corner and at the top of the stroke the piston shaft bent . I think vevor should limit the stroke length about 2 inches /50mm so it can carry the full load through its whole stroke. Luckily i bought a extra just in case and it turns out it was a good call. Otherwise great product , one nice touch would be having a pressure gauge on the side that shows how many tons the piston is putting out.