Reseñas de clientes para Motor eléctrico VEVOR de 0,75 HP, 1725 rpm, CA 115 V/230 V, bastidor 56, motor compresor de aire monofásico, eje con chaveta de 5/8", rotación en sentido horario/antihorario para maquinaria agrícola y equipos generales.

Purchased this back in July. 2026 and has been running perfectly would buy it again. Not a problem

Great value motor... Used for my restaurant hood system.

The motor runs good, but the only thing I am concerned with is that it seems to run hot to the touch. But I have not put a temperature reader on it to actually check it. Also the knock-outs on the wiring box wouldn't 'knock out'.

I did quite a bite of research and what was on the drill press was an open face motor which allowed dirt dobbers to build best inside the motor and eventually caused the motor to fail. This motor was a totally enclosed so eliminated that problem. The mount was adjustable to the press and the shaft and key way fit prefectiually. The motif runs quite and smooth and have used numerous times without any issues. The price was priced below the competition and I would highly recommend it if you are looking for a replacement motor.

Seems good. The junction box tabs are fully welded and don't pop out for access. I had to drill a hole.

Works like it should, was shocked how fast it got here, it was packed well, knock outs could be stamped a little better it was like trying to get the government to do something , getting them out of the junction box , worth the money

Great motor gor the cost

Motor arrived several days after ordering, sooner than expected. Opened box and spun shaft, spun easy. Hooked up motor to an old drill press I’m working on. Motor has a slight vibration but not bad. Amps checked out good. Have only used a couple of times but seems to be worth the price for a motor that will only be used every once in a while.

I bought this electric motor for a Logan Lathe under cabinet drive. The motor leads are just wires so you have to attach your wiring to these leads that are bundled in the connection box. I bought this motor not realizing it was a 4 pole electric motor which provides more torque. I am happy with it being a 4 pole motor but there were 9 leads in the connection box. Some of the terminology for the wires was hard to understand but it was covered in the provided documentation. I found one conflicting wire designation between the two provided documents for the motor but I made an educated guess that worked out. The discrepancy was for the call out of a wire that was described as not used but I needed it for the reverse function. Mine is wired to a main shut off switch and an in line forward/reversing switch. I have not mounted it to the lathe yet but I mocked up the wiring and have tested the motor with no load and it works in both forward/reverse. Hopefully it meets my expectations when mounted to power the lathe but I have a bunch of work to do to make that happen.

I bought this to replace my drill press motor. It has many wiring options with easy instructions. The build looks quality and it is more powerful than my old motor of the same size. It's been used twenty times or so and seems good. Only time will tell.