Reseñas de clientes para Motor eléctrico VEVOR de 1 HP, 1725 rpm, CA 115 V/230 V, chasis 56C, motor compresor de aire monofásico, eje con chaveta de 5/8", rotación en sentido horario/antihorario para maquinaria agrícola y equipos generales.

Love my electric motor but the issue was the “knock outs” on the junction box for installing an electric connector were fastened as if welded on and could not be removed. I needed to drill out and file the opening to install a connector. Overall I am very pleased and don’t wish to leave a negative review.

Works as advertised. No complaints from me.

I bought this to use to replace an old 1/2 hp motor (guessing it was a 1950s of 60s motor based on its label) on a 1939 wood lathe (I had to replace the bearings in the lathe headstock too). The motor finally stopped working. This new 1 hp motor, same 1725 rpm, really smoothed out the operation of the lathe as thr larger, longer, and heavier wood that the lathe is designed to take is just an easy turn now.

Motor for my planer works great and running so smoothly, i will purchase another one for my other tools if i need to. Good quality and easy to plug.

Just what I needed to replace the factory 1hp motor on my Central Pneumatics 16 speed floor drill press. It is a little bit bigger and heavier than the original motor but it works great.👍🏻

Installed this 1.5HP motor on vented hood exhaust blower almost a month ago. So far it was running good. I wired this motor to 208/230V. First impression is very good. The motor looks like it a good build and quality motor. However, it was just a month. :) If this motor will run 3-4 months trouble free, I would be definitely considering Vevor motors for future jobs.

That is an awesome motor! It’s super quiet and great power! Now I need the same one but 5hp. Can you guys make it? 5hp 1ph 1725rpm 230v 56c frame

Purchased this motor as a replacement for my Dads large Craftrsman tablesaw. Bolted up perfectly and runs quietly. No vibration. It took a bit to figure out the wiring because it had extra wires compared to the original.

Put this motor on a wood lathe I built for turning bowls. Easy to wire. Plenty of power. Turned an 11 inch diameter platter with no bogging down at all.

Motor is a great bargain for the price, work perfectly out of the box Came wired as 120 needed to switch that over to 240. Not too hard to do but does need a little thought to get all the wires correct, directions or very easy to follow