Reseñas de clientes para Motor eléctrico VEVOR de 2 HP, 1725 rpm, CA 115 V/230 V, chasis 56C, motor compresor de aire monofásico, eje con chaveta de 5/8", rotación en sentido horario/antihorario para maquinaria agrícola y equipos generales.

Purchased the motor to replace the motor on a SouthBend lathe Works great and very quite Would by it again

Replace an old 1.5HP compressor motor with the 2HP electric motor 1725 RPM running with 230v, worked as it should (had to change to run Clockwise vice CCW as it came running CCW. Wiring was easy to understand (if you are use to working with motor wiring). Seems heavy duty, quiet and smooth. Started the old 2 stage compressor with no issues. Would recommend.

This motor being rated at twice what the saw came with has worked perfectly. I wired it to run on 240v to keep the current draw lower. The instructions for wiring 120v or 240v and reversing directions are fairly straightforward. This motor having a thermal overload is a big plus. The bolt pattern and shaft size were the same as the 0.75hp motor that I burnt up within a few hours of first running the saw. This motor was a bit larger and required a bit of modification to the enclosure for it to fit, but it has been a great upgrade. I would recommend this motor and will buy again from Vevor as long as they continue to keep their prices right.

Just what I needed to replace the factory 1hp motor on my Central Pneumatics 16 speed floor drill press. It is a little bit bigger and heavier than the original motor but it works great.👍🏻

This 2HP motor is a horse. Lots of torque. I am using it for an old belt drive milling machine. It's not really the best motor for this application. It is an agriculture and compressor type motor because it is not a high end, balanced motor. It has a bit of vibration to it. I mounted it like the previous 1HP motor and when it came on I thought a plane was taking off it caused such a roar to the whole machine. I double rubber mounted it and everything runs smoothly. Now, the problem is it starts so fast with all that torque that it is going to eventually tear out my rubber mounts. I have ordered a soft start controller to hopefully remedy that super fast start up. Other than those factors to consider it is a solid running motor at a great price. This motor has to be rubber mounted. I also switched over to a magnetic contactor as the switch on the machine is only rated for 10A and now I have a 20A motor. I get to use my old front switch to activate the contactor with less than half an amp so it will save the contacts in the switch from the high amperage arching this 2HP motor requires.

The customer service was great. I bought a 2 HP motor and it was damaged when I got it out of the box. They sent me a replacement part and I was able to replace the bent part and now it works perfectly. The 4 stars is just because of the damaged product but I didn’t put that on vevor. I think that was the shipping company’s fault.

The motor runs good, but the only thing I am concerned with is that it seems to run hot to the touch. But I have not put a temperature reader on it to actually check it. Also the knock-outs on the wiring box wouldn't 'knock out'.

Seems good. The junction box tabs are fully welded and don't pop out for access. I had to drill a hole.

Overall this motor has been great. I’m happy with putting this on my bandsaw. I doubled the hp and it’s cutting aluminum and some steel great. The only issue I have was the knock out. I could not get them to come out and bent up the pecker head.

Price was good. Way heavier than my old 3/4 hp motor. Can tell it is on my table saw. Knock outs in box to connect wires are not knockouts. Need to drill them out to wire it. Only used few times so can’t tell if it will last