Reseñas de clientes para Cortadora de metal eléctrica VEVOR de 625 W, 1000 RPM, rotor de alta velocidad, 4 mm (0,16 pulgadas), 110 V, cuchillas reemplazables, estuche de almacenamiento, para cortar chapa metálica, acero inoxidable y aluminio.

Used it for cutting roofing metal. Cuts quickly, but a bit challenging to cut straight. Slightly rough cuts get tucked away behind trim anyway, so no worries. Beats all hell out of tin snips! Or any other methods of cutting. Quite impressed. Fast delivery too.

Cumple totalmente , es una maquina que esta sobrada y por el precio es un excelente producto. Adicionalmente tengo el requerimiento de un corte recto y liso pero el acabado no es estético sin embargo si lo recomiendo.

I bought this nibbler with the 4mm capacity to cut 10GA sheet metal for building a stove. The steel shop didn't have 10 so they would give me 8 or 9 gauge for tje same price. This unit is listed as 4mm which is between 8 and 9 gauge sheet so I bought a 4ftx8ft sheet of gauge (0.150") steel. I cut the sheet into 15 pieces with the nibbler. Found thay if I set a straight edge 5/8" Outside my cut line it would cut to the line. Halfway through the third or fourth cut the until stopp cutting. It took me a few minutes to realize the rotating head had come loose. I tightened it back down and had no more issues other than running into my clamps and other obstructions. This was the best $153 I have spent in awhile. The motor got warm but it chewed up gauge steel just as advertised. It comes with spare brushes, a spare set of teeth, and a spanner wrench.

I used to cut industrial steel went through like butter great nibbler for price

I was helping my stepson design and install a cantilevered roof extension on his lean-to shed. We extended the roof to the side by 40 inches. It was 14 feet long. Right in the middle of this extension is a large 20-inch diameter tree. We were using corrugated steel roofing and would need to cut the corrugated roofing sheets to accommodate the tree. I purchased this nibbler before we started the project because I know we were going to have to cut the metal roofing. In all we made several semicircle cuts in three sheets of roofing. Using this nibbler was like using scissors to cut paper! I couldn't believe how easy and fast this thing cut those roofing panels. It literally took less than 30 seconds to cut each proofing panel. What a time saver and hand saver! No tin snips needed. We are very pleased with the purchase of this nibbler!

Good tool for the price. Did what was needed

Overall it looks great. Missing the three tools to service the tool as listed on the web site and in the manual. Waiting to hear back from vevor. Also curious to see if replacement punches and anvil are available.

The sheet metal nibbler worked just as good as others costing over twice the price,I wasn't expecting much, but it works great, cuts thicker metal, 10 gauge no problem at all

Excellent quality, great price, will buy again!

The unit is a little awkward heavy. If you're trying to cut straight lines you will need good jigs. It cuts (about a 1/4" slot) clean with no dust and is one of the quietest metal cutting devises we have used. Overall a good product!