Reseñas de clientes para Taladro magnético VEVOR, 1100 W, diámetro de perforación de 1,57", 12000 N/2697 lbf, taladro de columna eléctrico portátil con 12 brocas, velocidad máxima de 580 RPM, ideal para cualquier superficie y mejoras del hogar.

The treds of one handal hole where not tap right!. Had too re tap it to get handal to fit right,chine Quality at its best.but it's still cheap.

For the money it's a great magnetic drill, sticks harder than i'd expected it too. More height would be usefull, once you put the chuck in it you don't have a lot of height adjustment left. But the worst part for me was finding out the On/Off switch in not an NVR switch. So I plugged it in once I got it out of the box and it ran at full power. Very unusual for a power tool like this not to have a switch that returns to off when power is disconnected, so be careful

Drills chuck keeps falling out. Also the handles keep vibrating loose and falling out and same on lubricant bottle holder. I have used this about ten times and had an issue at least every other time. The drill chuck falling out is biggest issue.

Voor een enkele licht klus gaat goed

Drill works well but cutting fluid leaks from the fan motor. So when it’s running it sprays cutting fluid all over

Wenn man normal bohrt ist das Gerät durchaus OK. Aber bei größeren Kronenbohrern versucht das Gerät die Drehzahl nachzujustieren, was aber nicht gelingt ... dann dreht er entweder zu schnell oder zu langsam und kann sich nicht einjustieren.

The drill performance well, the bits are poor quality

Bonjour, J'ai percé de l'acier sur 22mm épaisseur avec un diamètre 42… le travail se fait bien avec les fraises. Par contre il y a un problème avec la régularisation de vitesse qui ne reste pas constante. Donc le perçage se fait plus lentement.

The magnets where not as powerful as I would have liked. Bits wore out after 5 or 6 holes...

I was very disappointed by the absence of the advertised 2" annular drill bit but Vevor did give me a modest refund to compensate. Still, this unit isn't quite what I thought after discovering that it does not enable any change in drill speed. Each drill bit requires a different speed. Apparently, some models do. Finally, I found the printed manual to be totally useless. It tells you very little of what you need to know and the level of English grammar is atrocious. For example it does not tell you what to put into the cooling reservoir (water, cutting oil) or how to regulate flow. Much of it reads as gibberish. I probably should have elected to return it but accepted the partial refund b/c I really need to get the work done so will put up with it.