Reseñas de clientes para VEVOR Tanque de presión para pintura en aerosol, 30 L/8 galones, con agitador manual, sellador de fugas para la industria, decoración del hogar, arquitectura, construcción, pintura automotriz, 70 PSI máx.

I gutted the inside to use as a pressure pot for epoxy molds. My projects come out bubble free.

I needed a bigger pressure pot for resin casting. This came fully assembled. I only needed to remove two pipes from the inside to make it a pressure pot instead of a paint pot. Same quality as the other name brand.

Grundsätzlich ist der Topf top. Jedoch hat er innen eine stange welche die arbeit mit Resin etwas mühsam macht. Leider gibt es keine möglichkeit die zu entfernen. Weshalb ich bei höheren Resin dingen eher davon abraten würde. Wenn man das rohr abnehmen könnte wäre er perfekt. Wir wollen die verlängerung jedoch nicht Gewaltsam entfernen aus sicherheitshründen. Also atbeiten wir bestmöglich rund herum

Dear Vevor team, This is to inform you that I recently bought one of your paint sprayer, a 10 litre pressure paint pot feed spray gun 1.5mm Nozzle Paint sprayer for 10 litter capacity painting. My doubt is, do I use it with an air compressor? If not, how can the paint pot feed build pressure inside the tank that release the spray. Counting to hear from you anytime soon. Regards, Edward Wilson

Très très bien je recommande Au début du mal l apprivoiser Du bon travail pour le prix Très bon rapport qualité prix

Nog niet in gebruik maar ziet er goed uit

The product is good except that needs some improvements. The two transparent pipes are to stiff and get curled easily thus making it difficult sometimes to handle. There should be a pipe extension connected to the straight pipe in the tank so as not to have left over paint which cannot be sprayed out and also to have a mesh filter. The rest is fine

Bought this with the intent to spray water based finish. I didn't bother using the guns or hoses that came with it. Pressure pot itself seems durable

Un produit qui aide bien lorsque l'on filtre la peinture ! OU Alors il faut nettoyer le nez du pistolet sans arrêt !!! Donc Filtrer la peinture avant de la mettre dans l'appareil pour peindre !

Converted this pressure pot for resin casting and after a week of buying the wrong connectors I was finally able to use my car tire inflator to pressurize the pot. A small jump start/tire inflator battery can get about 30psi before dying out. After a 12hr period my pressure dropped about 2-4psi. I was able to get the psi up to 40 before the dice fully cured. Everything worked out perfectly despite the tiny leak.