Reseñas de clientes para VEVOR - Tornillo de banco de fresado de alta resistencia de 3 pulgadas, tornillo de banco de alta precisión, ancho de mordaza de 3 pulgadas con base giratoria de 360 grados, tornillo de banco CNC

Très bon rapport qualité prix. Qualité générale satisfaisante. Juste un petit bémol, une poignée amovible classique serait plus pratique.

La morsa è di ottimo materiale ed ha una buona precisione della scala graduata. Consigliata per uso hobbistico e semiprofessionale

I knew what I was getting into so I wasn't disappointed by what I received. The basic manufacturing process was good and the item is solid and square. But, the finish was known to be poor; not the paint but the corners. You have to be prepared to take the item completely to pieces (which is easy enough to do) and go over all the edges and corners with a file, none of which have been addressed in the factory. After that it is a very good mill vice, without that - wear gloves!

Très belle qualité. Sauf la poignée horrible, quasiment brute de fonderie, mal ajustée et énorme pour ce petit étau! Je préfère utiliser une clé à œil. J'aurais bien aimé aussi que la couronne graduée soit indexable (mobile et non fixe) afin d'offrir toujours un affichage orienté au plus pratique pour l'utilisateur...(Mais là, ce serait du luxe!).

I have three of these vises with different configurations and am pleased with all of them. Understand this is no Kurt vise, but for the money, Vevor has put together a pretty good product.

very please with unit as a hobbiest unit fits oerfecton my 3in1 17/20 shoptask lathe mill. accuracy is very good for price and was well packaged and delivary was fast.

Sve u redu! Još jedna kupovina putem Vevora i ne bude zadnja jer do sada sve što sam kupio solidne je kvalitete i cjenovno prihvatljivo. Brza realizacija narudžbe kao i dostava ! Sve preporuke kupcima !

Average vice, used it on my small milling machine. Found a crack on one of the bolt holes on the fixed clamp head, when I disassembled it for cleaning. I could fix it though, but don't know if it has the same strength......time will tell

It will do the job, But first there's a lot of work to be done. You must tear it all apart, every bit and scrub the hell out of it to get the cosmoline packing grease off of it. After a few hours of that break out the files and take all of the sharp edges off. And after a few more hours of that you need to oil and grease the lead screw and thrust bearings, then after that you get to start lapping the swivel base to true up the mating surfaces before you can think of bolting to your mill table. My time is money, and I'm invested deep before I can even use it. Yes after all of that it's a damn good mill vise.

Bon produit, dommage qu'il ait reçu un choc, heureusement au niveau de l'hexagone de la poignée, un coup de lime devrait régler le problème