Reseñas de clientes para VEVOR Torno de metal, mini torno 210x800, cambio de velocidad variable de 2500 RPM, mini torno de precisión de 850 W, torno para trabajar metales con motor sin escobillas, fresadora para varios tornea

this lathe does everything i need it to, but where do i get parts for it? The speed control circuitry needs to be replaced and i dont see a Vevor online parts store

La banda del motor del torno se reventó, dónde pudiera comprarla ? El modelo del torno tal como se muestra en la foto es YS-2180A

Working very well, love it

Overall it is a really nice machine, however; it does not come with the 10 mm bolts to fasten the bottom tray.

Had it for almost a year now, and for the price it has done well. However it would have been nice to know before buying, that the lead screws are all in a metric pitch and won't cut SAE threads. Motor lacks power as well, has a tendency to stall out on single point threading.

This lathe is a good buy for the money I did have to go over it and tweak it a bit and file some spots other than that it runs quiet and has great power..also the reason I bought it is because of the 1.5" spindle bore.. really enjoying this machine.

Not really 31 inches between centers unless you remove the chuck and tailstock. Closer to 26 inches.

I purchased this lathe two years ago. Over these last two years, I have discovered that: -The ways are not nicely ground. The surface is relatively rough and a lip was left over the entire bed. A file will easily cut them, I don't think that they're very hard. -The headstock casting was bad. The bore for the bearings didn't clean up and the bearings are not properly supported. -The retaining system for the saddle is a poor design. That's more set by the original design, but the thickness of the ways to-underside where the retaining strips are isn't consistent across the length of the bed. -The gibs on the the compound came bent. -The saddle isn't flat. It's admitted close to flat, but it has a slight rock in it. -The motor isn't brushless on the one I got. As far as I have been able to use it, which is almost none, it has worked, but it was a lie to me. -The lead screw has no shear pin. Mine is now slightly bent. My fault, but still a design failure. The only good part that actually worked properly out of the box was the cross slide. It was adjusted properly and is smooth. The only other good part is the dials on the compound and cross slide. They function as you would want. In general, it's clear to me that the lathe I got was built out of parts that didn't meet spec. It's been a total lemon.

Give me my money back for your garbage product and take your garbage product back. Give me my money back for your garbage product and you can have your garbage product back

After over 2 months, item never arrived, ZERO tracking information, horrible customer service experience with no help only automated responses GET YOU ACT TOGETHER VEVOR!!!! LEARN HOW TO GIVE VALID INFORMATION!!