Reseñas de clientes para Ventilador de conducto en línea VEVOR de 8 pulgadas y 750 CFM con controlador de velocidad variable, silencioso, con motor de CA, para refrigeración, carpas de cultivo e hidroponía.

Hooked up to ductwork to vent out near the roof peak. East to install, quiet and affordable I connected it at its highest speed setting to a thermostat-controlled switch.

Nice fan for the price, moves a lot of air, but is not the right choice if noise is an issue.

El usuario pensó que el producto era muy bueno y le dio una reseña de 5 estrellas.

Solid so far, I use it for my mushroom farm. It can handle high humidity + heavy spore loads for several months without cleaning. Almost all of the fan can be disassembled and cleaned with un-mounting the fan which is a huge bonus for my farm. Much easier to clean than Vivosun.

I have 3 of these in my house. My house was built in the 1930's and this is notoriously bad for AC on the second floor. I have had to place booster fans for my upstairs bedrooms to get the flow strong enough to climb the long journey up the middle of the house and into the rooms. These boosters create an immense amount of airflow. I keep them on low and they work wonderfully. If I leave the doors open in the bedrooms, I could turn them on high and cool the entire second floor. They do make a humming noise that comes from the vent when they are on but you dont notice it after a short while.

Got this fab to use for a steam hood for when I brew beer. It works great, incredible amount of suction. I adapted it to a 36” range hood and couldn’t be happier.

Blows the hot air from pellets stove to the other end of trailer and keeps the room 65 degrees when it is-25

This equipment is very effective,I set this up in my garage, suspended in the ceiling with straps. Immediately I could feel the difference in the garage, when I check the duct outside I was amazed by the amount of air leaving the garage. I recommend this product from Vevor. Amazing company.

This has been the savior of my fume extraction problems for the past two years. I even had a blade break off and I broke the blade off on the opposite side and it still works like a charm. I would definitely recommend this particular ventilation fan again and again.

I bought this fan as part of the exhaust system for my flameworking set up. I've been using it for a couple months now and it's working perfectly! Set up was easy but we struggled a bit with directionality of some parts after we disassembled - moral of the story is to pay attention when you take something apart so you can put it back together correctly again! It's louder than I expected, but given the amount of air it moves and the price, it's a fair trade off. I probably could have gotten by with the smaller unit for my needs.