Reseñas de clientes para Conjunto de frenos eléctricos para remolque VEVOR, 30,5 x 5 cm, kit de 2 pares de frenos eléctricos autoajustables para eje de 3217 kg, montaje de 5 orificios, placas de respaldo para reemplazo de piezas del sistema de frenado (2 derechas + 2 izquierdas)

This kit does not include the fastening nuts, a new cotter pin and worst of all the rear bearing is installed with the rear seal pressed into place. In order to properly grease the rear bearing the rear seal needs to be removed and this will damage the rear seal so you will then need to purchase new rear seals. Shipping these without the rear seal installed would fix this issue.

I was especially impressed with the quality of the equipment and the fact that the brake plates were already assembled. However, the instructions were less than worthless. Since the inner bearing is already installed and held in place with a grease seal, this presented a problem. On older axels such as mine, the spindle is not fitted with a zerk, and grease cannot be pumped into the inner bearing. I have been packing wheel bearings for over 60 years, but there is no way to adequately grease the inner bearing while it is inside the drum. Fortunately, I have a hydraulic press in my garage, which was necessary to remove the bearing and seal so the bearing could be packed. Also, if one is inexperienced with trailer brakes, it is possible to install them incorrectly. The backing plates are marked for right and left, ut which, to your thinking, is the right and left side of the trailer. Even if one figures this out, it is still possible to install the break plate incorrectly. A picture of a correctly installed brake backing plate would help.

Product seemed good enough, but was poorly packed and destroyed in shipping. The magnet was cracked, and brakes were mostly blown apart as the springs and auto tensioners were loose in the box. It took a few weeks and several e-mails back and forth to get a refund. A more secure box, better padding and more than a thin piece of foam between units might have resulted in a 5 star review. The customer service process was slow and tedious with at least 24-48 hours between each communication, needing to contact the technical department, receive low ball offers, and delay after delay. I had the initial product in in a few days, but weeks to resolve the damaged product.

I ordered 2 pair for a double axle trailer for a total of 4 hubs and brake assemblies. I only received 3. My repair took 2 weeks longer than expected and had to buy the 4th hub and brake assy from somewhere else because they dont sell them individually. The whole customer service is a joke. It is all by chat and they only respond once a day. If I could have talk to someone, the issue could have been resolved in 5 minutes. On a side note the packaging was horrible. The boxes were torn and partially open.

Only one worked I’m going have to buy from a quality shop

I bought 4 brake assembly and when they arrived the boxes were all beat up, but thats usually the case with heavy brake parts! I assembled them and 2 of the brake/hub assemblies would not spin well at all. I found that both had very bent backing plates and one of the drums was casted poorly and had sharp imperfections inside the drum. I grinded down the sharp spot but they still wouldn't turn. I tried everything i could to straighten the backing plates. I did also swap parts around to make sure thats definitely what was wrong. I contacted vevor and the conversation took over 2 weeks of only getting 1 response a day between 1-3am which was annoying and after trying all the things I already did over again as they suggested they offered me 30$ back and told me to hit the brake shoes with a hammer until they fit! I had enough at that point and I just sent it hammering on them and they just were so beat up by the time they didn't rub that i wasn't willing to even run them. So I ended up buying 2 dexter assemblies which worked perfectly and that was that. So id say its a gamble to buy vevors products. They 100% will not help you at all atleast in my experience atleast. The quality r we ally wasn't bad but if they dont show up perfect apparently thats that and they won't help you! Whether or not you roll the dice is up to you. I won't again thats for sure.

Ordered two brakes and one was damaged.

One of the brakes came damaged which was refunded. The second one was shifted and wouldn't fit in the drum. I was told to try adjusting it. I was never able to adjust it to fit in the drum. Get what you pay for

Les performances de freinage ne sont pas terribles, je crois que les aimants ne sont pas très performants. Même si on auguemente le output sur le module de frein électrique c’est pas extra, pour le reste ca va.

One of the brake shoes had damage and I reached out to CS but have heard nothing back. So, to me bad CS means bad product. If CS would have responded so there was a resolution on the damaged brake pad, I would have given everything a 5. I have already sent multiple photos