Reseñas de clientes para Motor eléctrico VEVOR de 1 HP, 3450 rpm, CA 115 V/230 V, chasis 56C, motor compresor de aire monofásico, eje con chaveta de 5/8", rotación en sentido horario/antihorario para maquinaria agrícola y equipos generales.

Works well, I did wire it 220v due to current draw. Meets expectations and works well as a replacement on belt sander.

Replace an old 1.5HP compressor motor with the 2HP electric motor 1725 RPM running with 230v, worked as it should (had to change to run Clockwise vice CCW as it came running CCW. Wiring was easy to understand (if you are use to working with motor wiring). Seems heavy duty, quiet and smooth. Started the old 2 stage compressor with no issues. Would recommend.

Working very well on my car lift. The motor was very simple to install I would definitely recommend this motor for projects around the house.

This motor being rated at twice what the saw came with has worked perfectly. I wired it to run on 240v to keep the current draw lower. The instructions for wiring 120v or 240v and reversing directions are fairly straightforward. This motor having a thermal overload is a big plus. The bolt pattern and shaft size were the same as the 0.75hp motor that I burnt up within a few hours of first running the saw. This motor was a bit larger and required a bit of modification to the enclosure for it to fit, but it has been a great upgrade. I would recommend this motor and will buy again from Vevor as long as they continue to keep their prices right.

Just what I needed to replace the factory 1hp motor on my Central Pneumatics 16 speed floor drill press. It is a little bit bigger and heavier than the original motor but it works great.👍🏻

I would’ve given five stars except I had a little problem. The punch outs for the cable box were not deep enough, and I ended up having to drill a hole. I changed out the motor on my table saw. It’s a craftsman. It wasn’t easy, but it worked. It wasn’t easy because of the clearance of the mounting plate and the screws.

The motor runs good, but the only thing I am concerned with is that it seems to run hot to the touch. But I have not put a temperature reader on it to actually check it. Also the knock-outs on the wiring box wouldn't 'knock out'.

Seems good. The junction box tabs are fully welded and don't pop out for access. I had to drill a hole.

Works good

Overall this motor has been great. I’m happy with putting this on my bandsaw. I doubled the hp and it’s cutting aluminum and some steel great. The only issue I have was the knock out. I could not get them to come out and bent up the pecker head.