Reseñas de clientes para Sierra de cinta VEVOR con soporte, 9,65 pulgadas, 560 y 1100 RPM, sierra de cinta de sobremesa de dos velocidades, motor de 370 W y 1/2 HP, altura de corte de 6'', longitud de hoja de sierra de 72,13'', con guía y calibre de inglete, para carpintería, aluminio y plástico.

Arrived in wood box with no padding. Parts all over the place. Several large scratches along table. Missing parts. Rusted bolts and pins. Requested refund. Vevor sent refund and did not want it returned as it was 238 LBS.

This saw runs good but I have had this saw for a year now and still cannot get it to cut straight. I bought it for resawing wood but so far haven't been able to use it.

Cette machine est en carton!!!! aucune rigidité. Même correctement serré la table bouge. DANGER ! 1/ Le système de blocage du guide de coupe ne reste pas en position IL SE DEVEROUILLE DURANT LA COUPE ! 2/ le système de guide de la lame réglable en hauteur à un jeu TRES IMPORTANT; La lame perd totalement l'appui sur le roulement arrière entre la position haute et basse. Le roulement arrière se retrouve trop loin entre la position haute et basse. Mème serré au maximum l'ensemble recule. CASSE A la demande du fabriquant j'ai forcé sur la poignée de serrage du guide de coupe qui a cassé. Machine achetée pour couper de la mousse inutilisable. Merci à VEVOR qui toutefois après de nombreux échanges a trouvé une solution. Avec un guide qui se desserre en cours de coupe, le risque de se couper est majeure, je pense que cette machine ne répond pas aux normes de sécurité et devrait être retirée du catalogue .

nog steeds NIET geleverd !!!!!!!!!

Schwer einzustellen. Sägeblatt ist minderwertig

Works as it should but damaged when opening base was bent. Needed rubber mallet to straighten

I entered a ticket for tech support. Still waiting for reply. No way to call. Glad I finally figured it out but user manual leaves a lot to be desired. It says there’s a quick release on back to reset blade which mine did not have at all even though part number on unit was exact number on manual. I had to disassemble the entire bracket to move the wheel down. The blade came off immediately upon machine start up so my first user experience was spending a couple hours trying to figure out how to reinstall. None of what I had to do was covered in the manual. Pictures in the manual were of low quality and essentially useless. It was riddled with grammatical and spelling errors and even conflicting information. For example it says turn blade tension wheel counter clockwise to both loosen and tighten blade. Once I got it running, it seems ok but I probably wouldn’t buy again due to poor experience. It would be a major hassle to ship this thing back and since I can’t talk to anyone, I doubt I could get a return number.

Was just what I needed for some craft projects. Could benefit from better blade guides however. Worked well for small projects..

Pas de notice en Français. Difficile à régler. Manque de puissance du moteur.

Dann lieber Scheppach o.ä.