Reseñas de clientes para Cizalla manual para chapa VEVOR, sin garganta, para múltiples usos, con marco de acero sólido, montaje a presión, espesor máximo de corte de 1,8 mm (0,07 pulg.) para acero, cobre, barras de refuerzo y aluminio.

Esto no corta patina el engranaje quisiera devolverlo por k no vale pa na

Pessimo articolo, sicuramente dal prezzo cosi contenuto l avrei dovuto capire fin da subito, tuttavia avevo necessità di una taglierina e questa era l unica disponibile in pochi giorni. E' praticamente inutilizzabile, oltre ad essere vecchia, si percepisce dallo stato di usura della vernice che sia stata prodotta qualche anno fa e conservata male in deposito. Presenta un errore tecnico che è rappresentato da uno "scalino", che rende impossibile un taglio non sbeccato. Non trovo quale altro utilizzo se ne possa fare, di certo non taglia fogli di allumino neanche di 4/10 di spessore (poco più di un foglio di carta. Sconsigliatissimo

Don't buy. Price was tempting. i just got around to using it. See the pics. Anvil and blade don't line up. This thing wouldn't cut cardboard. Either the anvil or the blade will have to be ground down to work. I'm surprised there wasn't any shims to add or subtract. I would expect it to at least work once before I have to fix/modify it.

The description says it will cut steel to .08 (80 thousandths) thick, which is 14 gauge steel. I am using a lot of 16ga HOT ROLLED steel, and it will not cut it. I have had to resort to using a plasma cutter or friction blade and trimming/finishing. To see what it would cut, I cut some 20gauge aluminum sheet just fine, as well as some 20gauge hot rolled steel. Even cold-rolled steel at 18 gauge would not cut. So, since I bought this to do 16 gauge steel, its a big disappointment. But I do a lot of circuit board work and it cuts FR4 easily so I'll keep it for that. One reviewer says he uses it to cut 12Gauge steel, I dont see how.

I am afraid to say this is not very good quality used it first time and broke not very robust and engeeniring is of a low quality so not good

Does not want to cut sheet metal it slips a lot

unit will not cut seems the cutter are not aligned properly. I'm requesting a refund.

seems to to be okay on the thinner metals, haven't given it much of a workout yet.

the shear is ok but very hard to use on flat bar

after about 4 hours of fixing the shear it works good, all bearing holes were stamped out not round . i had to round holes add bearings now it works good . i call this a kit shear