Reseñas de clientes para Motor eléctrico VEVOR de 2 HP, 1725 rpm, CA 115 V/230 V, chasis de 143/5 T, compresor de aire monofásico, eje de chaveta de 7/8", rotación en sentido horario/antihorario para maquinaria agrícola y equipos generales.

Works for intended purpose

Overall this motor has been great. I’m happy with putting this on my bandsaw. I doubled the hp and it’s cutting aluminum and some steel great. The only issue I have was the knock out. I could not get them to come out and bent up the pecker head.

Price was good. Way heavier than my old 3/4 hp motor. Can tell it is on my table saw. Knock outs in box to connect wires are not knockouts. Need to drill them out to wire it. Only used few times so can’t tell if it will last

Motor arrived quickly, and was very well packaged. I ordered the face mount version, and unfortunately it came with the foot mount also attached. In my application there wasn’t room for the foot mount and it was a big job removing it. Just to be clear no where in the literature did they say the foot mount would be eliminated. Cheers Chas

Great motor for shop equipment

So far good. Vevor replaced a motor that was over 50 yrs old, so expectations are high. I installed using the auxiliary electrical instructions which are different than the one on the motor. The auxiliary instructions bypass the thermal heat protection feature which I thought was curious but I will not be using in any type of continuous use operation or heavy duty didn't investigate it further. Checked out motor before installing to verify that runs both cw & ccw. I installed it in my drill press without any modification of base. I test ran it without issues.

Well I ordered this motor to replace mine on a table saw. I am somewhat disappointed that the motor is, physically larger, but seems to work flawlessly. By it being a larger motor the belt guard doesn't fit any more but I'll deal with it as the motor has enough power to drive my saw.

Motor arrived several days after ordering, sooner than expected. Opened box and spun shaft, spun easy. Hooked up motor to an old drill press I’m working on. Motor has a slight vibration but not bad. Amps checked out good. Have only used a couple of times but seems to be worth the price for a motor that will only be used every once in a while.

We bought for our greenhouse per the contractor. When arrived it was the wrong size although the contractor said it was his fault. You also do not have the proper one to replace it. We have tried to contact you to return it with no avail. Everyone says your products are great, but not customer service.

what a waster motor not working